| /linux-master/drivers/spi/ |
| H A D | spi-mt65xx.c | 1287 dev_warn(&pdev->dev, "Failed to resume hardware (%pe)\n", ERR_PTR(ret));
|
| H A D | spi-imx.c | 1907 dev_warn(spi_imx->dev, "failed to enable clock, skip hw disable\n");
|
| H A D | spi-lm70llp.c | 244 dev_warn(&pd->dev, "spi_bitbang_start failed with status %d\n",
272 dev_warn(&pd->dev, "spi_new_device failed\n");
|
| /linux-master/drivers/rtc/ |
| H A D | rtc-pcf8523.c | 64 dev_warn(&pcf8523->rtc->dev, "Unknown quartz-load-femtofarads value: %d. Assuming 12500",
444 dev_warn(&client->dev, "failed to set xtal load capacitance: %d",
|
| H A D | rtc-m41t80.c | 924 dev_warn(&client->dev, "unable to request IRQ, alarms disabled\n");
|
| H A D | rtc-max31335.c | 639 dev_warn(&client->dev,
|
| H A D | rtc-ds1511.c | 315 dev_warn(&pdev->dev, "voltage-low detected.\n");
337 dev_warn(&pdev->dev, "interrupt not available.\n");
|
| H A D | interface.c | 373 dev_warn(&rtc->dev, "alarm rollover not handled\n");
380 dev_warn(&rtc->dev, "invalid alarm value: %ptR\n",
|
| H A D | class.c | 265 dev_warn(dev, "/aliases ID %d not available\n", of_id);
422 dev_warn(rtc->dev.parent, "failed to add char device %d:%d\n",
|
| /linux-master/drivers/rpmsg/ |
| H A D | rpmsg_char.c | 520 dev_warn(&rpdev->dev, "failed to destroy endpoints: %d\n", ret);
|
| H A D | rpmsg_ctrl.c | 201 dev_warn(&rpdev->dev, "failed to nuke endpoints: %d\n", ret);
|
| /linux-master/drivers/remoteproc/ |
| H A D | stm32_rproc.c | 275 dev_warn(&rproc->dev, "no resource table found for this firmware\n");
392 dev_warn(dev, "cannot get %s mbox\n", name);
512 dev_warn(&rproc->dev, "warning: remote FW detach without ack\n");
530 dev_warn(&rproc->dev, "warning: remote FW shutdown without ack\n");
800 dev_warn(dev, "m4 state not supported\n");
811 dev_warn(dev, "rsc tbl syscon not supported\n");
|
| H A D | ti_k3_dsp_remoteproc.c | 185 dev_warn(dev, "local-reset deassert back failed\n");
213 dev_warn(dev, "module-reset assert back failed\n");
765 dev_warn(dev, "local reset is deasserted for device\n");
|
| H A D | remoteproc_core.c | 713 dev_warn(dev->parent,
766 dev_warn(dev, "DMA address cast in 32bit to fit resource table format\n");
1053 dev_warn(dev, "unsupported vendor resource %d\n",
1059 dev_warn(dev, "unsupported resource %d\n", hdr->type);
1201 dev_warn(dev,
|
| H A D | remoteproc_virtio.c | 401 dev_warn(dev, "vdev %d buffer already mapped\n",
491 dev_warn(dev, "can't remove vdev child device: %d\n", ret);
523 dev_warn(dev, "Failed to set DMA mask %llx. Trying to continue... (%pe)\n",
|
| H A D | qcom_q6v5_mss.c | 1048 dev_warn(qproc->dev,
|
| H A D | imx_rproc.c | 485 dev_warn(priv->dev, "Translation failed: da = 0x%llx len = 0x%zx\n",
|
| H A D | imx_dsp_rproc.c | 926 dev_warn(&rproc->dev, "no resource table found for this firmware\n");
|
| /linux-master/drivers/regulator/ |
| H A D | core.c | 2197 dev_warn(dev,
2209 dev_warn(dev, "supply %s not found, using dummy regulator\n", id);
2215 dev_warn(dev,
3870 dev_warn(&rdev->dev, "Failed to decrease supply voltage: %pe\n",
|
| /linux-master/drivers/platform/surface/aggregator/ |
| H A D | core.c | 320 dev_warn(&serdev->dev, "setup: unsupported flow control (value: %#04x)\n",
340 dev_warn(&serdev->dev, "setup: unsupported parity (value: %#04x)\n",
|
| /linux-master/drivers/platform/chrome/ |
| H A D | cros_ec_typec.c | 77 dev_warn(dev, "try-power-role not found: %d\n", ret);
626 dev_warn(typec->dev, "Failed to get mux info for port: %d, err = %d\n",
688 dev_warn(typec->dev,
742 dev_warn(typec->dev,
993 dev_warn(typec->dev, "Failed to register partner PD device, port: %d\n", port_num);
1004 dev_warn(typec->dev, "Failed to register source caps, port: %d\n", port_num);
1012 dev_warn(typec->dev, "Failed to register sink caps, port: %d\n", port_num);
1026 dev_warn(typec->dev, "EC_CMD_TYPEC_STATUS failed for port: %d\n", port_num);
1038 dev_warn(typec->dev,
1057 dev_warn(type
[all...] |
| /linux-master/drivers/phy/tegra/ |
| H A D | xusb.c | 1184 dev_warn(&pdev->dev, "deprecated DT, using legacy driver\n");
|
| /linux-master/drivers/phy/realtek/ |
| H A D | phy-rtk-usb3.c | 262 dev_warn(rtk_phy->dev, "Don't update rx_offset_range (rx_offset_code=0x%x, rx_offset_range=0x%x)\n",
|
| /linux-master/drivers/phy/ |
| H A D | phy-core.c | 259 dev_warn(&phy->dev, "phy_power_on was called before phy_init\n");
638 dev_warn(phy_provider->dev, "Requested PHY is disabled\n");
|
| /linux-master/drivers/nvme/host/ |
| H A D | apple.c | 228 dev_warn(anv->dev, "RTKit crashed; unable to recover without a reboot");
597 dev_warn(anv->dev, "invalid id %d completed", command_id);
900 dev_warn(anv->dev,
918 dev_warn(anv->dev,
929 dev_warn(anv->dev, "I/O %d(aq:%d) timeout: resetting controller\n",
992 dev_warn(anv->dev, "ctrl state %d is not RESETTING\n", state);
1114 dev_warn(anv->ctrl.device,
1151 dev_warn(anv->ctrl.device,
1167 dev_warn(anv->ctrl.device, "Reset failure status: %d\n", ret);
|