Revert r330897:

This was intended to be a non-functional change. It wasn't. The commit
message was thus wrong. In addition it broke arm, and merged crypto
related code.

Revert with prejudice.

This revert skips files touched in r316370 since that commit was since
MFCed. This revert also skips files that require $FreeBSD$ property
changes.

Thank you to those who helped me get out of this mess including but not
limited to gonzo, kevans, rgrimes.

Requested by: gjb (re)

Partial merge of the SPDX changes

These changes are incomplete but are making it difficult
to determine what other changes can/should be merged.

No objections from: pfg

Copy head@r302406 to stable/11 as part of the 11.0-RELEASE cycle.
Prune svn:mergeinfo from the new branch, as nothing has been merged
here.

Additional commits post-branch will follow.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Netlogic XLP network driver update

Changes are to
- update board and network interface detection logic
- fix reading onboard CPLD in little-endian config
- print NAE frequency conrrectly for Bx chips
- update XAUI config to disable Rx/Tx until interface is up

Submitted by: Venkatesh J V <venkatesh.vivekanandan@broadcom.com>

Broadcom XLP updates for the new firmware

Support few more versions of board firmware. In case the security
block is disabled, enable it at boot. Also increase the excluded
memory region to cover the area used by the firmware to initialize
devices.

Support for XLP4xx and XLP 8xx B0 revision

- Add 4xx processor IDs, add workaround in CPU detection code.
- Update frequency detection code for XLP 8xx.
- Add setting device frequency code.
- Update processor ID checking code.

MIPS XLP platform code update.

* Update the hardware access register definitions and functions to bring
them in line with other Netlogic software.
* Update the platform bus to use PCI even for on-chip devices. Add a dummy
PCI driver to ignore on-chip devices which do not need driver.
* Provide memory and IRQ resource allocation code for on-chip devices
which cannot get it from PCI config.
* add support for on-chip PCI and USB interfaces.
* update conf files, enable pci and retain old MAXCPU until we can support
>32 cpus.

Approved by: re(kib), jmallett

Add MIPS platform files for Netlogic XLP SoC.

Processor, UART, PIC and Messaging Network code. Also add
sys/mips/nlm/hal for on-chip device registers.

In collaboration with: Prabhath Raman <prabhathpr at netlogicmicro com>

Approved by: bz(re), jmallett, imp(mips)