| /linux-master/drivers/media/usb/dvb-usb/ |
| H A D | dib07x0.h | 6 GPIO0 = 0, enumerator in enum:dib07x0_gpios
|
| H A D | dib0700_devices.c | 39 * has a LNA on GPIO0 which is enabled by setting 1 */
95 dib0700_set_gpio(adap->dev, GPIO0, GPIO_OUT, 1);
97 dib0700_set_gpio(adap->dev, GPIO0, GPIO_OUT, 0);
323 dib0700_set_gpio(adap->dev, GPIO0, GPIO_OUT, 1);
475 dib0700_set_gpio(adap->dev, GPIO0, GPIO_OUT, 1);
721 dib0700_set_gpio(adap->dev, GPIO0, GPIO_OUT, 1);
1008 dib0700_set_gpio(adap->dev, GPIO0, GPIO_OUT, 1);
1066 dib0700_set_gpio(adap->dev, GPIO0, GPIO_OUT, 1);
1363 dib0700_set_gpio(adap->dev, GPIO0, GPIO_OUT, 1);
1397 dib0700_set_gpio(adap->dev, GPIO0, GPIO_OU
[all...] |
| /linux-master/drivers/net/wireless/realtek/rtl818x/rtl8187/ |
| H A D | rfkill.c | 24 gpio = rtl818x_ioread8(priv, &priv->map->GPIO0);
25 rtl818x_iowrite8(priv, &priv->map->GPIO0, gpio & ~priv->rfkill_mask);
|
| H A D | leds.c | 42 rtl818x_iowrite8(priv, &priv->map->GPIO0, 0x01);
80 rtl818x_iowrite8(priv, &priv->map->GPIO0, 0x01);
|
| H A D | dev.c | 678 rtl818x_iowrite8(priv, &priv->map->GPIO0, 0);
681 rtl818x_iowrite8(priv, &priv->map->GPIO0, 1);
704 rtl818x_iowrite8(priv, &priv->map->GPIO0, 0);
708 rtl818x_iowrite8(priv, &priv->map->GPIO0, 0x20);
|
| /linux-master/arch/arm/mach-pxa/ |
| H A D | pxa320.c | 26 MFP_ADDR_X(GPIO0, GPIO4, 0x0124),
|
| H A D | pxa300.c | 26 MFP_ADDR_X(GPIO0, GPIO2, 0x00b4),
|
| H A D | mfp-pxa2xx.h | 61 #define GPIO0_GPIO MFP_CFG_IN(GPIO0, AF0)
|
| H A D | mfp-pxa3xx.h | 12 #define GPIO0_GPIO MFP_CFG(GPIO0, AF0)
|
| H A D | mfp-pxa320.h | 76 #define GPIO0_DRQ MFP_CFG(GPIO0, AF2)
|
| H A D | mfp-pxa300.h | 429 #define GPIO0_DF_RDY MFP_CFG(GPIO0, AF1)
|
| /linux-master/drivers/pinctrl/ |
| H A D | pinctrl-lantiq.h | 107 GPIO0 = 0, enumerator in enum:ltq_pin
|
| H A D | pinctrl-xway.c | 115 MFP_XWAY(GPIO0, GPIO, EXIN, MII, TDM),
149 static const unsigned ase_exin_pin_map[] = {GPIO6, GPIO29, GPIO0};
153 static const unsigned ase_pins_exin2[] = {GPIO0};
243 MFP_XWAY(GPIO0, GPIO, EXIN, SDIO, TDM),
277 static const unsigned danube_exin_pin_map[] = {GPIO0, GPIO1, GPIO2};
279 static const unsigned danube_pins_exin0[] = {GPIO0};
418 MFP_XWAY(GPIO0, GPIO, EXIN, SDIO, TDM),
476 static const unsigned xrx100_exin_pin_map[] = {GPIO0, GPIO1, GPIO2, GPIO39, GPIO10, GPIO9};
478 static const unsigned xrx100_pins_exin0[] = {GPIO0};
631 MFP_XWAY(GPIO0, GPI
[all...] |
| H A D | pinctrl-falcon.c | 107 MFP_FALCON(GPIO0, RST, GPIO, NONE, NONE),
163 static const unsigned pins_por[] = {GPIO0};
|
| H A D | pinctrl-as3722.c | 152 AS3722_PINGROUP(gpio0, GPIO0),
|
| H A D | pinctrl-max77620.c | 165 MAX77620_PINGROUP(gpio0, GPIO0, LOW_POWER_MODE_CONTROL_IN),
|
| H A D | pinctrl-k210.c | 259 K210_FUNC(GPIO0, GPIO),
|
| /linux-master/arch/sh/kernel/cpu/sh4a/ |
| H A D | setup-shx3.c | 185 GPIO0, GPIO1, GPIO2, GPIO3, enumerator in enum:__anon41
232 INTC_VECT(GPIO0, 0xe40), INTC_VECT(GPIO1, 0xe60),
267 DU, GPIO3, GPIO2, GPIO1, GPIO0, PAM, 0, 0,
303 GPIO2, GPIO1, GPIO0, IRM } },
|
| H A D | setup-sh7786.c | 482 GPIO0, GPIO1, enumerator in enum:__anon70
527 INTC_VECT(GPIO0, 0xea0), INTC_VECT(GPIO1, 0xec0),
597 HSPI, GPIO0, GPIO1, Thermal,
636 { 0xfe410858, 0, 32, 8, /* INT2PRI22 */ { HSPI, GPIO0,
|
| /linux-master/drivers/net/wireless/realtek/rtl818x/ |
| H A D | rtl818x.h | 246 u8 GPIO0; /* 0x91 */ member in struct:rtl818x_csr
|
| /linux-master/drivers/regulator/ |
| H A D | da9121-regulator.c | 168 * GPIO0/1/2 are not configured for use by default, so should not be seen.
182 DA9121_STATUS(0, 2, GPIO0, 0, "Handled E_GPIO0\n"),
|
| /linux-master/drivers/mfd/ |
| H A D | axp20x.c | 603 INIT_REGMAP_IRQ(AXP288, GPIO0, 4, 0),
|
| H A D | db8500-prcmu.c | 321 IRQ_ENTRY(GPIO0),
|