Searched refs:BIT2 (Results 1 - 8 of 8) sorted by relevance
| /netgear-WNDR4500-V1.0.1.40_1.0.68/src/linux/linux-2.6/drivers/scsi/ |
| H A D | tmscsim.h | 191 #define BIT2 0x00000004 macro
198 #define FORMATING_MEDIA BIT2
204 #define ASPI_SUPPORT BIT2
210 #define SRB_MSGOUT BIT2 /*;arbitration+msg_out 1st byte*/
227 #define OVER_RUN BIT2
235 #define RESET_DONE BIT2
245 #define RESET_DEV0 BIT2
289 #define WIDE_ENABLE BIT2 /* Not used ;-) */
344 #define EN_DISCONNECT_ BIT2
351 #define RST_SCSI_BUS BIT2
[all...] |
| H A D | dc395x.h | 70 #define BIT2 0x00000004 macro
77 #define FORMATING_MEDIA BIT2
83 #define ASPI_SUPPORT BIT2
119 #define RESET_DONE BIT2
127 #define OVER_RUN BIT2
137 #define RESET_DEV0 BIT2
172 #define WIDE_NEGO_ENABLE BIT2
|
| /netgear-WNDR4500-V1.0.1.40_1.0.68/src/linux/linux-2.6/include/asm-arm/arch-integrator/ |
| H A D | bits.h | 28 #define BIT2 0x00000004 macro
|
| /netgear-WNDR4500-V1.0.1.40_1.0.68/src/linux/linux-2.6/include/linux/ |
| H A D | synclink.h | 22 #define BIT2 0x0004 macro
|
| /netgear-WNDR4500-V1.0.1.40_1.0.68/src/linux/linux-2.6/drivers/char/ |
| H A D | synclink_gt.c | 230 #define desc_eof(a) (le16_to_cpu((a).status) & BIT2)
2265 wr_reg16(info, TCR, (unsigned short)(val | BIT2)); /* set reset bit */
3758 /* SCR (serial control) BIT2=looopback enable */
3759 wr_reg16(info, SCR, (unsigned short)(rd_reg16(info, SCR) | BIT2));
3808 wr_reg16(info, RCR, (unsigned short)(val | BIT2)); /* set reset bit */
3833 wr_reg16(info, RCR, (unsigned short)(val | BIT2)); /* set reset bit */
3844 wr_reg32(info, RDCSR, (BIT2 + BIT0));
3847 wr_reg32(info, RDCSR, (BIT6 + BIT2 + BIT0));
3863 (unsigned short)((rd_reg16(info, TCR) | BIT1) & ~BIT2));
3894 wr_reg32(info, TDCSR, BIT2
[all...] |
| H A D | synclink.c | 514 #define TRANSMIT_DATA BIT2
532 #define RXSTATUS_ABORT BIT2
533 #define RXSTATUS_PARITY_ERROR BIT2
571 #define TXSTATUS_ALL_SENT BIT2
591 #define MISCSTATUS_DPLL_NO_SYNC BIT2
617 #define SICR_DPLL_NO_SYNC BIT2
643 * and Transmit Interrupt Control Register (TICR) (except BIT2, BIT0)
651 #define TXSTATUS_ALL_SENT BIT2
672 /* and Transmit Interrupt Control Register (TICR) (except BIT2, BIT0) */
1610 * BIT2 EO
[all...] |
| H A D | synclinkmp.c | 438 #define CDCD BIT2
454 #define CRCE BIT2
2666 if (status & BIT2 << shift)
2675 if (dmastatus & BIT2 << shift)
4452 case 7: RegValue |= BIT4 + BIT2; break;
4454 case 5: RegValue |= BIT5 + BIT4 + BIT3 + BIT2; break;
4589 RegValue |= BIT2 + BIT1;
4788 if ( !(status & BIT2))
4946 status &= ~BIT2;
4960 if (status & (BIT6+BIT5+BIT3+BIT2)) {
[all...] |
| /netgear-WNDR4500-V1.0.1.40_1.0.68/src/linux/linux-2.6/drivers/char/pcmcia/ |
| H A D | synclink_cs.c | 313 #define IRQ_DCD BIT2 // carrier detect status change
320 #define CEC BIT2 // command executing
325 #define PVR_RI BIT2
759 while (read_reg(info, (unsigned char)(channel+STAR)) & BIT2) {
1262 if (gis & (BIT3 + BIT2))
1309 if (pis & BIT2)
3159 val |= BIT2;
3231 val = read_reg(info, CHA + CCR1) | (BIT2 + BIT1 + BIT0);
3302 val |= BIT2;
3325 val |= BIT4 + BIT2;
[all...] |
Completed in 129 milliseconds