/linux-master/drivers/vfio/pci/ |
H A D | vfio_pci.c | 89 pci_warn(pdev, 95 pci_warn(pdev, "%04x:%04x exists in vfio-pci device denylist, driver probing disallowed.\n", 117 pci_warn(pdev, "Failed to setup Intel IGD regions\n");
|
H A D | vfio_pci_config.c | 1372 pci_warn(pdev, "%s: unknown length for PCI cap %#x@%#x\n", 1451 pci_warn(pdev, "%s: unknown length for PCI ecap %#x@%#x\n", 1581 pci_warn(pdev, "%s: PCI config conflict @%#x, was cap %#x now cap %#x\n", 1669 pci_warn(pdev, "%s: PCI config conflict @%#x, was ecap %#x now ecap %#x\n", 1794 pci_warn(pdev,
|
H A D | vfio_pci_core.c | 983 pci_warn(vdev->pdev, 990 pci_warn(vdev->pdev, 1905 pci_warn(pdev, 2073 pci_warn(vdev->pdev, 2240 pci_warn(pdev, "Cannot bind to PF with SR-IOV enabled\n");
|
/linux-master/drivers/i2c/busses/ |
H A D | i2c-amd-mp2-pci.c | 33 pci_warn(privdata->pci_dev, 189 pci_warn(pdev, "received msg but no cmd was sent (bus = %d)!\n", 233 pci_warn(pdev, "received irq without message\n");
|
/linux-master/drivers/pci/pcie/ |
H A D | dpc.c | 142 pci_warn(pdev, "root port still busy\n"); 273 pci_warn(pdev, "%s detected\n", 430 pci_warn(pdev, "request IRQ%d failed: %d\n", dev->irq,
|
H A D | aer_inject.c | 406 pci_warn(dev, "The correctable error(s) is masked by device\n"); 413 pci_warn(dev, "The uncorrectable error(s) is masked by device\n"); 468 pci_warn(edev->port, "AER service is not initialized\n");
|
H A D | err.c | 229 pci_warn(bridge, "subordinate device reset failed\n");
|
H A D | aspm.c | 1342 pci_warn(pdev, "can't disable ASPM; OS doesn't have ASPM control\n"); 1410 pci_warn(pdev, "can't override BIOS ASPM; OS doesn't have ASPM control\n");
|
/linux-master/drivers/pci/hotplug/ |
H A D | pciehp.h | 42 pci_warn(ctrl->pcie->port, format, ## arg)
|
H A D | shpchp.h | 59 pci_warn(ctrl->pci_dev, format, ## arg)
|
/linux-master/drivers/pci/ |
H A D | vpd.c | 69 pci_warn(dev, "failed VPD read at offset %zu\n", 151 pci_warn(dev, "VPD access failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update\n"); 579 pci_warn(dev, FW_BUG "disabling VPD access (can't determine size of non-standard VPD format)\n");
|
H A D | quirks.c | 1063 pci_warn(dev, "TI XIO2000a quirk detected; secondary bus fast back-to-back transfers disabled\n"); 1134 pci_warn(dev, "I/O APIC: AMD Erratum #22 may be present. In the event of instability try\n"); 1135 pci_warn(dev, " : booting with the \"noapic\" option\n"); 1310 pci_warn(dev, "BIOS failed to enable PCI standards compliance; fixing this error\n"); 1976 pci_warn(pdev, "could not add stall property"); 1992 pci_warn(dev, "PXH quirk detected; SHPC device MSI disabled\n"); 2465 pci_warn(dev, "Can't map e100 registers\n"); 2471 pci_warn(dev, "Firmware left e100 interrupts enabled; disabling\n"); 2686 pci_warn(dev, "MSI quirk detected; MSI disabled\n"); 2702 pci_warn(de [all...] |
H A D | iov.c | 456 pci_warn(pdev, "%d VFs already enabled. Disable before enabling %d VFs\n", 467 pci_warn(pdev, "%d VFs requested; only %d enabled\n", 936 pci_warn(dev, "driver left SR-IOV enabled after remove\n"); 1216 pci_warn(dev, "Cannot modify SR-IOV while VFs are assigned\n");
|
H A D | p2pdma.c | 507 pci_warn(root, "Host bridge not in P2PDMA whitelist: %04x:%04x\n", 644 pci_warn(client, "ACS redirect is set between the client and provider (%s)\n", 646 pci_warn(client, "to disable ACS redirect for this path, add the kernel parameter: pci=disable_acs_redir=%s\n", 655 pci_warn(client, "cannot be used for peer-to-peer DMA as the client and provider (%s) do not share an upstream bridge or whitelisted host bridge\n",
|
H A D | pci-acpi.c | 147 pci_warn(dev, "PCI settings rev %d not supported; using defaults\n", 219 pci_warn(dev, "PCI-X settings not supported\n"); 297 pci_warn(dev, "PCIe settings rev %d not supported\n", 535 pci_warn(dev, "Encountered _HPX type 3 with unsupported config space location"); 962 pci_warn(dev, "ACPI _RST failed\n");
|
H A D | bus.c | 354 pci_warn(dev, "device attach failed (%d)\n", retval);
|
H A D | probe.c | 1294 pci_warn(dev, "Primary bus is hard wired to 0\n"); 1347 pci_warn(dev, "bridge has subordinate %02x but max busn %02x\n", 2077 pci_warn(dev, "can't set Max Payload Size to %d; if necessary, use \"pci=pcie_bus_safe\" and report a bug\n", 2093 pci_warn(dev, "Max Payload Size %d, but upstream %s set to %d; if necessary, use \"pci=pcie_bus_safe\" and report a bug\n", 2115 pci_warn(dev, "can't set Max Payload Size to %d; if necessary, use \"pci=pcie_bus_safe\" and report a bug\n", 2797 pci_warn(dev, "Failed attempting to set the MRRS\n");
|
H A D | xen-pcifront.c | 278 pci_warn(dev, "MSI-X entry %d is invalid: %d!\n", 331 pci_warn(dev, "MSI entry is invalid: %d!\n",
|
H A D | pci.c | 994 pci_warn(dev, "cannot disable ACS redirect for this hardware as it does not have ACS capabilities\n"); 1285 pci_warn(dev, "not ready %dms after %s; giving up\n", 2502 pci_warn(dev, "can't enable PME#\n"); 3934 pci_warn(pdev, "BAR %d: can't reserve %pR\n", bar, 5071 pci_warn(pdev, "All device reset methods disabled by user"); 5115 pci_warn(pdev, "Device-specific reset disabled/de-prioritized by user"); 6261 pci_warn(dev, "Unable to allocate DMA alias mask\n"); 6500 pci_warn(dev, "Can't reassign resources to host bridge\n");
|
/linux-master/drivers/net/can/esd/ |
H A D | esd_402_pci-core.c | 158 pci_warn(pdev, "Error while setting MSI configuration:\n" 201 pci_warn(pdev,
|
/linux-master/drivers/net/ethernet/sfc/ |
H A D | efx_devlink.c | 656 pci_warn(efx->pci_dev, 659 pci_warn(efx->pci_dev,
|
H A D | ef100_rep.c | 380 pci_warn(efx->pci_dev,
|
/linux-master/drivers/media/pci/zoran/ |
H A D | zoran_card.c | 1011 pci_warn(zr->pci_dev, 1019 pci_warn(zr->pci_dev, "default_input value %d out of range (0-%d)\n", 1239 pci_warn(pdev, "%s: chipset does not support reliable PCI-PCI DMA\n",
|
H A D | zoran_device.c | 348 pci_warn(zr->pci_dev, "%s(1) with SnapShot on!?\n", __func__); 873 pci_warn(zr->pci_dev, "BuzIRQ with SnapShot off ???\n");
|
/linux-master/drivers/dma/dw-edma/ |
H A D | dw-edma-pcie.c | 355 pci_warn(pdev, "can't remove device properly: %d\n", err);
|