/linux-master/net/netfilter/ |
H A D | xt_time.c | 277 int minutes = sys_tz.tz_minuteswest; local 279 if (minutes < 0) /* east of Greenwich */ 281 -minutes / 60, -minutes % 60); 284 minutes / 60, minutes % 60);
|
/linux-master/drivers/rtc/ |
H A D | rtc-bq32k.c | 25 #define BQ32K_MINUTES_MASK 0x7F /* Mask over minutes value */ 43 uint8_t minutes; member in struct:bq32k_regs 103 if (regs.minutes & BQ32K_OF) 107 tm->tm_min = bcd2bin(regs.minutes & BQ32K_MINUTES_MASK); 123 regs.minutes = bin2bcd(tm->tm_min);
|
H A D | rtc-ds1685.c | 265 u8 seconds, minutes, hours, wday, mday, month, years; local 270 minutes = rtc->read(rtc, RTC_MINS); 286 tm->tm_min = ds1685_rtc_bcd2bin(rtc, minutes, RTC_MINS_BCD_MASK, 312 u8 ctrlb, seconds, minutes, hours, wday, mday, month, years, century; local 317 minutes = ds1685_rtc_bin2bcd(rtc, tm->tm_min, RTC_MINS_BIN_MASK, 360 rtc->write(rtc, RTC_MINS, minutes); 377 * There are three primary alarm registers: seconds, minutes, and hours. 388 u8 seconds, minutes, hours, mday, ctrlb, ctrlc; local 394 minutes = rtc->read(rtc, RTC_MINS_ALARM); 418 if (likely(minutes < 446 u8 ctrlb, seconds, minutes, hours, mday; local [all...] |
/linux-master/tools/testing/kunit/ |
H A D | run_checks.py | 20 TIMEOUT = datetime.timedelta(minutes=5).total_seconds()
|
/linux-master/drivers/hwmon/ |
H A D | ftsteutates.c | 60 minutes = 60 enumerator in enum:WATCHDOG_RESOLUTION 234 (resolution == minutes && (ret & BIT(1)) == 0)) { 259 /* switch watchdog resolution to minutes if timeout does not fit 264 resolution = minutes; 324 data->resolution = ret & BIT(1) ? seconds : minutes; 335 /* max timeout 255 minutes. */
|
/linux-master/include/trace/events/ |
H A D | v4l2.h | 138 __entry->timecode_minutes = buf->timecode.minutes; 150 "seconds = %u, minutes = %u, hours = %u, " 215 __entry->timecode_minutes = vbuf->timecode.minutes; 226 "frames = %u, seconds = %u, minutes = %u, hours = %u, "
|
/linux-master/drivers/usb/storage/ |
H A D | shuttle_usbat.c | 394 static int usbat_wait_not_busy(struct us_data *us, int minutes) argument 402 * but probably not more than 10 minutes or so. On the other hand, 404 * minutes! 407 for (i=0; i<1200+minutes*60; i++) { 432 msleep(1000); /* X minutes */ 435 usb_stor_dbg(us, "Waited not busy for %d minutes, timing out\n", 436 minutes); 479 int minutes, 506 return usbat_wait_not_busy(us, minutes); 525 int minutes) 475 usbat_write_block(struct us_data *us, unsigned char access, void* buf, unsigned short len, int minutes, int use_sg) argument 512 usbat_hp8200e_rw_block_test(struct us_data *us, unsigned char access, unsigned char *registers, unsigned char *data_out, unsigned short num_registers, unsigned char data_reg, unsigned char status_reg, unsigned char timeout, unsigned char qualifier, int direction, void *buf, unsigned short len, int use_sg, int minutes) argument [all...] |
/linux-master/drivers/power/supply/ |
H A D | max77693_charger.c | 412 unsigned long minutes) 416 if (minutes > 70) 419 data = minutes / 10; 411 max77693_set_top_off_timer(struct max77693_charger *chg, unsigned long minutes) argument
|
/linux-master/drivers/platform/x86/dell/ |
H A D | dell-laptop.c | 1049 * cbRES4, byte1 Maximum acceptable minutes value (0 if minutes not supported). 1167 u8 minutes; member in struct:kbd_info 1247 info->minutes = (buffer.output[3] >> 8) & 0xFF; 1463 if (kbd_info.minutes > 63) 1464 kbd_info.minutes = 63; 1581 if (value > kbd_info.minutes) 1627 } else if (value / 60 <= kbd_info.minutes && kbd_info.minutes) {
|
/linux-master/sound/drivers/ |
H A D | mts64.c | 137 u8 hours, u8 minutes, 351 u8 hours, u8 minutes, 364 mts64_write_command(p, minutes); 350 mts64_smpte_start(struct parport *p, u8 hours, u8 minutes, u8 seconds, u8 frames, u8 idx) argument
|
/linux-master/sound/pci/asihpi/ |
H A D | hpi_internal.h | 944 u16 minutes; member in struct:hpi_clock_msg 952 u16 minutes; member in struct:hpi_clock_res
|
/linux-master/tools/testing/ktest/ |
H A D | ktest.pl | 683 my $minutes = 0; 690 $minutes = int($time / 60); 691 $time -= $minutes * 60; 700 if ($minutes > 0) { 701 doprint "$minutes minute"; 702 doprint "s" if ($minutes > 1);
|
/linux-master/drivers/scsi/esas2r/ |
H A D | atvda.h | 953 u8 minutes; member in struct:atto_vda_date_and_time
|
/linux-master/sound/pci/rme9652/ |
H A D | hdspm.c | 4748 int a, ltc, frames, seconds, minutes, hours; local 4838 minutes = ltc & 0xF; 4840 minutes += (ltc & 0x7) * 10; 4847 hours, minutes, seconds, frames);
|
/linux-master/drivers/media/test-drivers/vivid/ |
H A D | vivid-vid-cap.c | 190 tc->minutes = (seq / (60 * fps)) % 60;
|
/linux-master/include/uapi/linux/ |
H A D | videodev2.h | 948 __u8 minutes; member in struct:v4l2_timecode
|
/linux-master/drivers/media/v4l2-core/ |
H A D | v4l2-ioctl.c | 469 tc->hours, tc->minutes, tc->seconds,
|
/linux-master/tools/power/pm-graph/ |
H A D | sleepgraph.py | 5595 # Print out a very concise time string in minutes and seconds 7124 finish += timedelta(minutes=sysvals.multitest['time'])
|