/linux-master/arch/m68k/fpsp040/ |
H A D | round.S | 78 | If sign of fp number = 0 (positive), then add 1 to l. 91 | If sign of fp number = 1 (negative), then add 1 to l. 280 | would go less than 0. In that case the number becomes a denorm - the 330 lsrl %d5,%d6 |by the number in the exp, then 430 bsr dnrm_lp |denormalize the number 447 bsr dnrm_lp |denormalize the number 460 bsr dnrm_lp |denormalize the number
|
H A D | x_operr.S | 255 | Destination is Dn. Get register number from d0. Data is on 258 andil #7,%d0 |isolate register number
|
/linux-master/drivers/usb/serial/ |
H A D | mos7720.c | 634 * Byte 1 IIR Port 1 (port.number is 0) 635 * Byte 2 IIR Port 2 (port.number is 1) 1319 unsigned char number; local 1327 number = port->port_number; 1339 write_mos_reg(serial, number, MOS7720_LCR, mos7720_port->shadowLCR); 1342 write_mos_reg(serial, number, MOS7720_DLL, (__u8)(divisor & 0xff)); 1343 write_mos_reg(serial, number, MOS7720_DLM, 1348 write_mos_reg(serial, number, MOS7720_LCR, mos7720_port->shadowLCR);
|
/linux-master/tools/testing/selftests/drivers/net/mlxsw/spectrum-2/ |
H A D | tc_flower.sh | 231 # The number of masks in a region is limited. Once the maximum 232 # number of masks has been reached filters that require new 665 local number=$(( $index + $TEST_RULE_BASE )) 666 printf -v hexnumber '%x' $number 669 handle $number flower $tcflags \ 686 local number=$(( $index + $TEST_RULE_BASE )) 687 printf -v hexnumber '%x' $number 690 handle $number flower\n" 989 # The number of eRP entries is limited. Once the maximum number o [all...] |
/linux-master/sound/pci/nm256/ |
H A D | nm256.c | 135 /* Mono/stereo flag, number of bits on playback, and rate mask. */ 341 snd_nm256_load_coefficient(struct nm256 *chip, int stream, int number) argument 358 number &= 7; 360 number += 8; 363 snd_nm256_load_one_coefficient(chip, stream, addr, number); 372 u32 offset = snd_nm256_get_start_offset(number); 373 u32 end_offset = offset + coefficient_sizes[number];
|
/linux-master/arch/arm/mm/ |
H A D | proc-v7.S | 323 * r3: contains MIDR rX number in bits 23-20 324 * r6: contains MIDR rXpY as 8-bit XY number 498 ubfx r0, r9, #4, #12 @ primary part number 501 ldr r10, =0x00000c08 @ Cortex-A8 primary part number 506 ldr r10, =0x00000c09 @ Cortex-A9 primary part number 511 ldr r10, =0x00000c0d @ Cortex-A12 primary part number 516 ldr r10, =0x00000c0e @ Cortex-A17 primary part number 521 ldr r10, =0x00000c0f @ Cortex-A15 primary part number
|
H A D | abort-lv4t.S | 213 and r6, r6, #15 @ number of regs to transfer 233 and r6, r6, #15 @ number of regs to transfer
|
/linux-master/drivers/iommu/intel/ |
H A D | irq_remapping.c | 37 unsigned int bus; /* PCI bus number */ 38 unsigned int devfn; /* PCI devfn number */ 294 * Set an IRTE to match only the bus number. Interrupt requests that reference 295 * this IRTE must have a requester-id whose bus number is between or equal 398 * If there are multiple aliases, all with the same bus number, 410 if (PCI_BUS_NUM(data.alias) != data.pdev->bus->number) 412 dev->bus->number); 414 set_irte_verify_bus(irte, dev->bus->number, dev->bus->number); 415 else if (data.pdev->bus->number ! [all...] |
/linux-master/sound/drivers/opl3/ |
H A D | opl3_lib.c | 243 tid.card = opl3->card->number; 264 tid.card = opl3->card->number;
|
/linux-master/arch/powerpc/platforms/ps3/ |
H A D | spu.c | 311 pr_debug("%s:%d spu_%d\n", __func__, __LINE__, spu->number); 337 pr_debug("%s:%d spu_%d\n", __func__, __LINE__, spu->number); 393 * For now, just create logical spus equal to the number
|
/linux-master/arch/powerpc/kernel/ |
H A D | pci_dn.c | 87 if (pdn->busno == bus->number && 119 if (pdn->busno == pdev->bus->number &&
|
/linux-master/arch/arm/kernel/ |
H A D | bios32.c | 37 if (dev->bus->number == 0 && dev->devfn == 0) 341 bus->number, (features & PCI_COMMAND_FAST_BACK) ? "en" : "dis"); 351 * root bus. This will return the slot number of the bridge device on the
|
/linux-master/arch/xtensa/lib/ |
H A D | memset.S | 48 srli a7, a4, 4 # number of loop iterations with 16B
|
/linux-master/drivers/pci/controller/ |
H A D | pci-ftpci100.c | 208 return faraday_raw_pci_read_config(p, bus->number, fn, config, size, value); 247 return faraday_raw_pci_write_config(p, bus->number, fn, config, size,
|
/linux-master/arch/powerpc/platforms/powernv/ |
H A D | ocxl.c | 45 * hardware supports a finite number of actags per link (64 for 49 * multiple AFUs. Each AFU advertises in its config space the number 145 link->bus == dev->bus->number && 156 link->bus = dev->bus->number; 268 * can allocate a pro-rated number of actags to each function. 288 * The number of PASIDs (process address space ID) which can
|
/linux-master/fs/lockd/ |
H A D | mon.c | 563 .number = 1, 577 .number = NSM_PROGRAM,
|
/linux-master/drivers/pci/hotplug/ |
H A D | ibmphp_pci.c | 94 ibmphp_pci_bus->number = cur_func->busno; 353 ibmphp_pci_bus->number = func->busno; 580 ibmphp_pci_bus->number = func->busno; 596 err("cannot allocate secondary bus number for the bridged device\n"); 600 debug("after find_sec_number, the number we got is %x\n", sec_number); 614 debug("subordinate number after write/read is %x\n", sec_number); 776 ibmphp_pci_bus->number = func->busno; 1071 ibmphp_pci_bus->number = busno; 1214 ibmphp_pci_bus->number = busno; 1321 ibmphp_pci_bus->number [all...] |
/linux-master/drivers/pinctrl/ |
H A D | pinctrl-axp209.c | 52 /* Stores the pins supporting LDO function. Bit offset is pin number. */ 54 /* Stores the pins supporting ADC function. Bit offset is pin number. */ 514 pctl->desc->pins->number, 515 pctl->desc->pins->number,
|
H A D | pinctrl-pef2256.c | 117 *pins = &pef2256->pctrl_desc.pins[selector].number; 180 .number = _number, \
|
/linux-master/drivers/infiniband/sw/siw/ |
H A D | siw_main.c | 112 static void siw_destroy_cpulist(int number) argument 116 while (i < number) 158 * Choose CPU with least number of active QP's from NUMA node of
|
/linux-master/drivers/atm/ |
H A D | suni.c | 302 printk(KERN_NOTICE "%s(itf %d): signal %s\n",dev->type,dev->number, 323 dev->number);
|
/linux-master/drivers/input/keyboard/ |
H A D | qt1050.c | 291 static int qt1050_set_key(struct regmap *map, int number, int on) argument 295 key_regs = qt1050_get_key_regs(number); 368 dev_err(dev, "Button without pad number\n");
|
/linux-master/arch/mips/pci/ |
H A D | pci-octeon.c | 67 * @slot: The slot number for this device on __BUS 0__. Linux 72 * Returns Interrupt number for the device 171 * Return the mapping of PCI device number to IRQ line. Each 227 * @slot: The slot number for this device on __BUS 0__. Linux 232 * Returns Interrupt number for the device 268 pci_addr.s.bus = bus->number; 302 pci_addr.s.bus = bus->number; 526 * MOST Indicates the maximum number of outstanding splits (in -1
|
/linux-master/drivers/pinctrl/intel/ |
H A D | pinctrl-intel.c | 844 * intel_gpio_to_pin() - Translate from GPIO offset to pin number 851 * automatically translated to pinctrl pin number. This function can be 854 * Return: a pin number and pointers to the community and pad group, which 892 * intel_pin_to_gpio() - Translate from pin number to GPIO offset 894 * @pin: pin number 896 * Translate the pin number of pinctrl to GPIO offset 1741 if (!intel_pinctrl_should_save(pctrl, desc->number)) 1744 val = readl(intel_get_padcfg(pctrl, desc->number, PADCFG0)); 1746 val = readl(intel_get_padcfg(pctrl, desc->number, PADCFG1)); 1749 padcfg = intel_get_padcfg(pctrl, desc->number, PADCFG [all...] |
/linux-master/sound/core/seq/ |
H A D | seq_virmidi.c | 376 rdev->card->number, 384 sprintf(pinfo->name, "VirMIDI %d-%d", rdev->card->number, rdev->device);
|