| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/usb/core/ |
| H A D | hcd.c | 751 dev_info (bus->controller, "new USB bus registered, assigned bus number %d\n", bus->busnum);
765 dev_info (bus->controller, "USB bus %d deregistered\n", bus->busnum);
1562 dev_info(hcd->self.controller, "%s\n", hcd->product_desc);
1617 dev_info(hcd->self.controller, "irq %d, %s 0x%08llx\n", irqnum,
1624 dev_info(hcd->self.controller, "%s 0x%08llx\n",
1671 dev_info(hcd->self.controller, "remove, state %x\n", hcd->state);
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/firmware/ |
| H A D | dcdbas.c | 259 dev_info(&dcdbas_pdev->dev, "%s: invalid magic value\n",
572 dev_info(&dev->dev, "%s (version %s)\n",
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/infiniband/hw/ipath/ |
| H A D | ipath_eeprom.c | 570 dev_info(&dd->pcidev->dev, "Bad I2C flash checksum: "
585 dev_info(&dd->pcidev->dev, "Warning, GUID %llx is "
|
| H A D | ipath_intr.c | 59 dev_info(&dd->pcidev->dev,
286 dev_info(&dd->pcidev->dev, "Link state changed from %s to %s\n",
734 dev_info(&dd->pcidev->dev, "%s packet problems\n",
990 dev_info(&dd->pcidev->dev, "error interrupt (%x), "
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/media/radio/ |
| H A D | radio-maestro.c | 418 dev_info(&pdev->dev, "version " DRIVER_VERSION " time " __TIME__ " "
420 dev_info(&pdev->dev, "radio chip initialized\n");
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/arch/ia64/sn/kernel/ |
| H A D | xpnet.c | 159 * dev_err(), dev_warn(), and dev_info().
641 dev_info(xpnet, "registering network device %s\n", XPNET_DEVICE_NAME);
704 dev_info(xpnet, "unregistering network device %s\n",
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/usb/misc/ |
| H A D | cytherm.c | 381 dev_info (&interface->dev,
414 dev_info(&interface->dev, "Cypress thermometer now disconnected\n");
|
| H A D | phidgetmotorcontrol.c | 388 dev_info(&intf->dev, "USB PhidgetMotorControl attached\n");
435 dev_info(&interface->dev, "USB PhidgetMotorControl detached\n");
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/net/usb/ |
| H A D | mcs7830.c | 306 dev_info(&dev->udev->dev, "applying rev.C fixup\n");
331 dev_info(&dev->udev->dev, "Cannot set autoneg\n");
|
| H A D | zaurus.c | 256 dev_info(&dev->udev->dev, "unsupported MDLM descriptors\n");
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/edac/ |
| H A D | e752x_edac.c | 172 const struct e752x_dev_info *dev_info; member in struct:e752x_pvt
890 pvt->dev_info->err_dev,
982 pvt->dev_info = &e752x_devs[dev_idx];
991 mci->ctl_name = pvt->dev_info->ctl_name;
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/hwmon/ |
| H A D | adm9240.c | 565 dev_info(&adapter->dev, "found %s revision %u\n",
641 dev_info(&client->dev, "Using VRM: %d.%d\n", data->vrm / 10,
646 dev_info(&client->dev, "status: config 0x%02x mode %u\n",
671 dev_info(&client->dev, "cold start: config was 0x%02x "
|
| H A D | w83l785ts.c | 215 dev_info(&adapter->dev,
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/i2c/busses/ |
| H A D | i2c-at91.c | 244 dev_info(&pdev->dev, "AT91 i2c bus driver.\n");
|
| H A D | i2c-i810.c | 213 dev_info(&dev->dev, "i810/i815 i2c device found.\n");
|
| H A D | i2c-nforce2.c | 256 dev_info(&smbus->adapter.dev, "nForce2 SMBus adapter at %#x\n", smbus->base);
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/i2c/chips/ |
| H A D | eeprom.c | 204 dev_info(&new_client->dev, "Vaio EEPROM detected, "
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/w1/masters/ |
| H A D | matrox_w1.c | 213 dev_info(&pdev->dev, "Matrox G400 GPIO transport layer for 1-wire.\n");
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/rtc/ |
| H A D | rtc-ds1672.c | 225 dev_info(&client->dev, "chip found, driver version " DRV_VERSION "\n");
|
| H A D | rtc-m48t86.c | 161 dev_info(&dev->dev, "battery %s\n",
|
| H A D | rtc-max6900.c | 274 dev_info(&client->dev,
|
| H A D | rtc-v3020.c | 198 dev_info(&pdev->dev, "Chip available at physical address 0x%llx,"
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/spi/ |
| H A D | spi_s3c24xx_gpio.c | 142 dev_info(&dev->dev, "registering %p: %s\n",
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/media/video/ovcamchip/ |
| H A D | ovcamchip_core.c | 393 dev_info(&c->dev, "Initializing chip as "
|
| /netgear-WNDR4500v2-V1.0.0.60_1.0.38/src/linux/linux-2.6/drivers/mtd/maps/ |
| H A D | physmap_of.c | 204 dev_info(&dev->dev, "Using OF partition information\n");
|