Copy stable/10@r272459 to releng/10.1 as part of
the 10.1-RELEASE process.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

s,KOBJMETHOD_END,DEVMETHOD_END,g in order to fully hide the explicit mention
of kobj(9) from device drivers.

uses KOBJMETHOD_END macro to indicate the end of method table.

Submitted by: yongari

Adds siba_bwn module which is used with bwn(4). Main purpose of this
module is to distinguish parts of Silicon Backplane and of Broadcom
Wireless.

Using svn cp rather than cp to copy these files over had the benefit
of preserving their history. It had the problem that it also copied
over mergeinfo data. Since we're retiring the projects/mips branch,
I'm removing the svn:mergeinfo property from them all.

Submitted by: jhb

Move this to the right location. Grump.

Merge from projects/mips to head by hand:

Merge the siba bus device. This was moved from mips to dev because
siba bus can be in other architectures, like ARM.

- Revert changes accidentally killed by merge operation

- Move Silicon Backplanes code out to system-wide level (dev/siba) as
it's going to be used not only for siba5 devices.

Create projects/ area for FreeBSD/MIPS development/experiments. It's supposed to substitute perforce mips2 branch.

As discussed on IRC and at BSDcan, move the mips32/* directories up a
level. The distinction was artificial. Some more movement around the
deck charis is likely depending on the fallout from this one.

Paths were corrected after the svn mv. Hope that's OK.

FreeBSD/mips port. The FreeBSD/mips port targets mips32, mips64,
mips32r2 and mips64r2 (and close relatives) processors. There
presently is support for ADMtek ADM5120, A mips 4Kc in a malta board,
the RB533 routerboard (based on IDT RC32434) and some preliminary
support for sibtye/broadcom designs. Other hardware support will be
forthcomcing.

This port boots multiuser under gxemul emulating the malta board and
also bootstraps on the hardware whose support is forthcoming...

Oleksandr Tymoshenko, Wojciech Koszek, Warner Losh, Olivier Houchard,
Randall Stewert and others that have contributed to the mips2 and/or
mips2-jnpr perforce branches. Juniper contirbuted a generic mips port
late in the life cycle of the misp2 branch. Warner Losh merged the
mips2 and Juniper code bases, and others list above have worked for
the past several months to get to multiuser.

In addition, the mips2 work owe a debt to the trail blazing efforts of
the original mips branch in perforce done by Juli Mallett.