1// SPDX-License-Identifier: GPL-2.0 2#include <linux/module.h> 3#include <linux/platform_device.h> 4#include <linux/dma-mapping.h> 5#include <linux/usb/otg.h> 6#include <linux/usb/usb_phy_generic.h> 7#include <linux/slab.h> 8#include <linux/clk.h> 9#include <linux/of.h> 10#include <linux/of_address.h> 11#include <linux/usb/of.h> 12 13#include "phy-am335x-control.h" 14#include "phy-generic.h" 15 16struct am335x_phy { 17 struct usb_phy_generic usb_phy_gen; 18 struct phy_control *phy_ctrl; 19 int id; 20 enum usb_dr_mode dr_mode; 21}; 22 23static int am335x_init(struct usb_phy *phy) 24{ 25 struct am335x_phy *am_phy = dev_get_drvdata(phy->dev); 26 27 phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, am_phy->dr_mode, true); 28 return 0; 29} 30 31static void am335x_shutdown(struct usb_phy *phy) 32{ 33 struct am335x_phy *am_phy = dev_get_drvdata(phy->dev); 34 35 phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, am_phy->dr_mode, false); 36} 37 38static int am335x_phy_probe(struct platform_device *pdev) 39{ 40 struct am335x_phy *am_phy; 41 struct device *dev = &pdev->dev; 42 int ret; 43 44 am_phy = devm_kzalloc(dev, sizeof(*am_phy), GFP_KERNEL); 45 if (!am_phy) 46 return -ENOMEM; 47 48 am_phy->phy_ctrl = am335x_get_phy_control(dev); 49 if (!am_phy->phy_ctrl) 50 return -EPROBE_DEFER; 51 52 am_phy->id = of_alias_get_id(pdev->dev.of_node, "phy"); 53 if (am_phy->id < 0) { 54 dev_err(&pdev->dev, "Missing PHY id: %d\n", am_phy->id); 55 return am_phy->id; 56 } 57 58 am_phy->dr_mode = of_usb_get_dr_mode_by_phy(pdev->dev.of_node, -1); 59 60 ret = usb_phy_gen_create_phy(dev, &am_phy->usb_phy_gen); 61 if (ret) 62 return ret; 63 64 am_phy->usb_phy_gen.phy.init = am335x_init; 65 am_phy->usb_phy_gen.phy.shutdown = am335x_shutdown; 66 67 platform_set_drvdata(pdev, am_phy); 68 device_init_wakeup(dev, true); 69 70 /* 71 * If we leave PHY wakeup enabled then AM33XX wakes up 72 * immediately from DS0. To avoid this we mark dev->power.can_wakeup 73 * to false. The same is checked in suspend routine to decide 74 * on whether to enable PHY wakeup or not. 75 * PHY wakeup works fine in standby mode, there by allowing us to 76 * handle remote wakeup, wakeup on disconnect and connect. 77 */ 78 79 device_set_wakeup_enable(dev, false); 80 phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, am_phy->dr_mode, false); 81 82 return usb_add_phy_dev(&am_phy->usb_phy_gen.phy); 83} 84 85static void am335x_phy_remove(struct platform_device *pdev) 86{ 87 struct am335x_phy *am_phy = platform_get_drvdata(pdev); 88 89 usb_remove_phy(&am_phy->usb_phy_gen.phy); 90} 91 92#ifdef CONFIG_PM_SLEEP 93static int am335x_phy_suspend(struct device *dev) 94{ 95 struct am335x_phy *am_phy = dev_get_drvdata(dev); 96 97 /* 98 * Enable phy wakeup only if dev->power.can_wakeup is true. 99 * Make sure to enable wakeup to support remote wakeup in 100 * standby mode ( same is not supported in OFF(DS0) mode). 101 * Enable it by doing 102 * echo enabled > /sys/bus/platform/devices/<usb-phy-id>/power/wakeup 103 */ 104 105 if (device_may_wakeup(dev)) 106 phy_ctrl_wkup(am_phy->phy_ctrl, am_phy->id, true); 107 108 phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, am_phy->dr_mode, false); 109 110 return 0; 111} 112 113static int am335x_phy_resume(struct device *dev) 114{ 115 struct am335x_phy *am_phy = dev_get_drvdata(dev); 116 117 phy_ctrl_power(am_phy->phy_ctrl, am_phy->id, am_phy->dr_mode, true); 118 119 if (device_may_wakeup(dev)) 120 phy_ctrl_wkup(am_phy->phy_ctrl, am_phy->id, false); 121 122 return 0; 123} 124#endif 125 126static SIMPLE_DEV_PM_OPS(am335x_pm_ops, am335x_phy_suspend, am335x_phy_resume); 127 128static const struct of_device_id am335x_phy_ids[] = { 129 { .compatible = "ti,am335x-usb-phy" }, 130 { } 131}; 132MODULE_DEVICE_TABLE(of, am335x_phy_ids); 133 134static struct platform_driver am335x_phy_driver = { 135 .probe = am335x_phy_probe, 136 .remove_new = am335x_phy_remove, 137 .driver = { 138 .name = "am335x-phy-driver", 139 .pm = &am335x_pm_ops, 140 .of_match_table = am335x_phy_ids, 141 }, 142}; 143 144module_platform_driver(am335x_phy_driver); 145MODULE_LICENSE("GPL v2"); 146