1# SPDX-License-Identifier: GPL-2.0
2#
3# Kconfig for uClinux(non-paged MM) depend configurations
4# Hyok S. Choi <hyok.choi@samsung.com>
5# 
6
7config SET_MEM_PARAM
8	bool "Set flash/sdram size and base addr"
9	help
10	 Say Y to manually set the base addresses and sizes.
11	 otherwise, the default values are assigned.
12
13config DRAM_BASE
14	hex '(S)DRAM Base Address' if SET_MEM_PARAM
15	default 0x00800000
16
17config DRAM_SIZE
18	hex '(S)DRAM SIZE' if SET_MEM_PARAM
19	default 0x00800000
20
21config FLASH_MEM_BASE
22	hex 'FLASH Base Address' if SET_MEM_PARAM
23	depends on CPU_ARM740T || CPU_ARM946E || CPU_ARM940T
24	default 0x00400000
25
26config FLASH_SIZE
27	hex 'FLASH Size' if SET_MEM_PARAM
28	depends on CPU_ARM740T || CPU_ARM946E || CPU_ARM940T
29	default 0x00400000
30
31config PROCESSOR_ID
32	hex 'Hard wire the processor ID'
33	default 0x00007700
34	depends on !(CPU_CP15 || CPU_V7M)
35	help
36	  If processor has no CP15 register, this processor ID is
37	  used instead of the auto-probing which utilizes the register.
38
39config REMAP_VECTORS_TO_RAM
40	bool 'Install vectors to the beginning of RAM'
41	help
42	  The kernel needs to change the hardware exception vectors.
43	  In nommu mode, the hardware exception vectors are normally
44	  placed at address 0x00000000. However, this region may be
45	  occupied by read-only memory depending on H/W design.
46
47	  If the region contains read-write memory, say 'n' here.
48
49	  If your CPU provides a remap facility which allows the exception
50	  vectors to be mapped to writable memory, say 'n' here.
51
52	  Otherwise, say 'y' here.  In this case, the kernel will require
53	  external support to redirect the hardware exception vectors to
54	  the writable versions located at DRAM_BASE.
55
56config ARM_MPU
57       bool 'Use the ARM v7 PMSA Compliant MPU'
58       depends on CPU_V7 || CPU_V7M
59       default y if CPU_V7
60       help
61         Some ARM systems without an MMU have instead a Memory Protection
62         Unit (MPU) that defines the type and permissions for regions of
63         memory.
64
65         If your CPU has an MPU then you should choose 'y' here unless you
66         know that you do not want to use the MPU.
67