1/*- 2 * SPDX-License-Identifier: BSD-3-Clause 3 * 4 * Copyright (c) 1991 The Regents of the University of California. 5 * All rights reserved. 6 * 7 * Redistribution and use in source and binary forms, with or without 8 * modification, are permitted provided that the following conditions 9 * are met: 10 * 1. Redistributions of source code must retain the above copyright 11 * notice, this list of conditions and the following disclaimer. 12 * 2. Redistributions in binary form must reproduce the above copyright 13 * notice, this list of conditions and the following disclaimer in the 14 * documentation and/or other materials provided with the distribution. 15 * 3. Neither the name of the University nor the names of its contributors 16 * may be used to endorse or promote products derived from this software 17 * without specific prior written permission. 18 * 19 * THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND 20 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 21 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 22 * ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE 23 * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 24 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS 25 * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) 26 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT 27 * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 28 * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF 29 * SUCH DAMAGE. 30 */ 31 32/* 33 * NS8250... UART registers. 34 */ 35 36/* 8250 registers #[0-6]. */ 37 38#define com_data 0 /* data register (R/W) */ 39#define REG_DATA com_data 40 41#define com_ier 1 /* interrupt enable register (W) */ 42#define REG_IER com_ier 43#define IER_ERXRDY 0x1 44#define IER_ETXRDY 0x2 45#define IER_ERLS 0x4 46#define IER_EMSC 0x8 47/* 48 * Receive timeout interrupt enable. 49 * Implemented in Intel XScale, Ingenic XBurst. 50 */ 51#define IER_RXTMOUT 0x10 52 53#define IER_BITS "\20\1ERXRDY\2ETXRDY\3ERLS\4EMSC\5RXTMOUT" 54 55#define com_iir 2 /* interrupt identification register (R) */ 56#define REG_IIR com_iir 57#define IIR_IMASK 0xf 58#define IIR_RXTOUT 0xc 59#define IIR_BUSY 0x7 60#define IIR_RLS 0x6 61#define IIR_RXRDY 0x4 62#define IIR_TXRDY 0x2 63#define IIR_NOPEND 0x1 64#define IIR_MLSC 0x0 65#define IIR_FIFO_MASK 0xc0 /* set if FIFOs are enabled */ 66 67#define IIR_BITS "\20\1NOPEND\2TXRDY\3RXRDY" 68 69#define com_lcr 3 /* line control register (R/W) */ 70#define com_cfcr com_lcr /* character format control register (R/W) */ 71#define REG_LCR com_lcr 72#define LCR_DLAB 0x80 73#define CFCR_DLAB LCR_DLAB 74#define LCR_EFR_ENABLE 0xbf /* magic to enable EFR on 16650 up */ 75#define CFCR_EFR_ENABLE LCR_EFR_ENABLE 76#define LCR_SBREAK 0x40 77#define CFCR_SBREAK LCR_SBREAK 78#define LCR_PZERO 0x30 79#define CFCR_PZERO LCR_PZERO 80#define LCR_PONE 0x20 81#define CFCR_PONE LCR_PONE 82#define LCR_PEVEN 0x10 83#define CFCR_PEVEN LCR_PEVEN 84#define LCR_PODD 0x00 85#define CFCR_PODD LCR_PODD 86#define LCR_PENAB 0x08 87#define CFCR_PENAB LCR_PENAB 88#define LCR_STOPB 0x04 89#define CFCR_STOPB LCR_STOPB 90#define LCR_8BITS 0x03 91#define CFCR_8BITS LCR_8BITS 92#define LCR_7BITS 0x02 93#define CFCR_7BITS LCR_7BITS 94#define LCR_6BITS 0x01 95#define CFCR_6BITS LCR_6BITS 96#define LCR_5BITS 0x00 97#define CFCR_5BITS LCR_5BITS 98 99#define com_mcr 4 /* modem control register (R/W) */ 100#define REG_MCR com_mcr 101#define MCR_PRESCALE 0x80 /* only available on 16650 up */ 102#define MCR_LOOPBACK 0x10 103#define MCR_IE 0x08 104#define MCR_IENABLE MCR_IE 105#define MCR_DRS 0x04 106#define MCR_RTS 0x02 107#define MCR_DTR 0x01 108 109#define MCR_BITS "\20\1DTR\2RTS\3DRS\4IE\5LOOPBACK\10PRESCALE" 110 111#define com_lsr 5 /* line status register (R/W) */ 112#define REG_LSR com_lsr 113#define LSR_RCV_FIFO 0x80 114#define LSR_TEMT 0x40 115#define LSR_TSRE LSR_TEMT 116#define LSR_THRE 0x20 117#define LSR_TXRDY LSR_THRE 118#define LSR_BI 0x10 119#define LSR_FE 0x08 120#define LSR_PE 0x04 121#define LSR_OE 0x02 122#define LSR_RXRDY 0x01 123#define LSR_RCV_MASK 0x1f 124 125#define LSR_BITS "\20\1RXRDY\2OE\3PE\4FE\5BI\6THRE\7TEMT\10RCV_FIFO" 126 127#define com_msr 6 /* modem status register (R/W) */ 128#define REG_MSR com_msr 129#define MSR_DCD 0x80 130#define MSR_RI 0x40 131#define MSR_DSR 0x20 132#define MSR_CTS 0x10 133#define MSR_DDCD 0x08 134#define MSR_TERI 0x04 135#define MSR_DDSR 0x02 136#define MSR_DCTS 0x01 137 138#define MSR_BITS "\20\1DCTS\2DDSR\3TERI\4DDCD\5CTS\6DSR\7RI\10DCD" 139 140/* 8250 multiplexed registers #[0-1]. Access enabled by LCR[7]. */ 141#define com_dll 0 /* divisor latch low (R/W) */ 142#define com_dlbl com_dll 143#define com_dlm 1 /* divisor latch high (R/W) */ 144#define com_dlbh com_dlm 145#define REG_DLL com_dll 146#define REG_DLH com_dlm 147 148/* 16450 register #7. Not multiplexed. */ 149#define com_scr 7 /* scratch register (R/W) */ 150 151/* 16550 register #2. Not multiplexed. */ 152#define com_fcr 2 /* FIFO control register (W) */ 153#define com_fifo com_fcr 154#define REG_FCR com_fcr 155#define FCR_ENABLE 0x01 156#define FIFO_ENABLE FCR_ENABLE 157#define FCR_RCV_RST 0x02 158#define FIFO_RCV_RST FCR_RCV_RST 159#define FCR_XMT_RST 0x04 160#define FIFO_XMT_RST FCR_XMT_RST 161#define FCR_DMA 0x08 162#define FIFO_DMA_MODE FCR_DMA 163#define FCR_RX_LOW 0x00 164#define FIFO_RX_LOW FCR_RX_LOW 165#define FCR_RX_MEDL 0x40 166#define FIFO_RX_MEDL FCR_RX_MEDL 167#define FCR_RX_MEDH 0x80 168#define FIFO_RX_MEDH FCR_RX_MEDH 169#define FCR_RX_HIGH 0xc0 170#define FIFO_RX_HIGH FCR_RX_HIGH 171 172#define FCR_BITS "\20\1ENABLE\2RCV_RST\3XMT_RST\4DMA" 173 174/* 16650 registers #2,[4-7]. Access enabled by LCR_EFR_ENABLE. */ 175 176#define com_efr 2 /* enhanced features register (R/W) */ 177#define REG_EFR com_efr 178#define EFR_CTS 0x80 179#define EFR_AUTOCTS EFR_CTS 180#define EFR_RTS 0x40 181#define EFR_AUTORTS EFR_RTS 182#define EFR_EFE 0x10 /* enhanced functions enable */ 183 184#define com_xon1 4 /* XON 1 character (R/W) */ 185#define com_xon2 5 /* XON 2 character (R/W) */ 186#define com_xoff1 6 /* XOFF 1 character (R/W) */ 187#define com_xoff2 7 /* XOFF 2 character (R/W) */ 188 189#define DW_REG_USR 31 /* DesignWare derived Uart Status Reg */ 190#define com_usr 39 /* Octeon 16750/16550 Uart Status Reg */ 191#define REG_USR com_usr 192#define USR_BUSY 1 /* Uart Busy. Serial transfer in progress */ 193#define USR_TXFIFO_NOTFULL 2 /* Uart TX FIFO Not full */ 194 195/* 16950 register #1. Access enabled by ACR[7]. Also requires !LCR[7]. */ 196#define com_asr 1 /* additional status register (R[0-7]/W[0-1]) */ 197 198/* 16950 register #3. R/W access enabled by ACR[7]. */ 199#define com_rfl 3 /* receiver fifo level (R) */ 200 201/* 202 * 16950 register #4. Access enabled by ACR[7]. Also requires 203 * !LCR_EFR_ENABLE. 204 */ 205#define com_tfl 4 /* transmitter fifo level (R) */ 206 207/* 208 * 16950 register #5. Accessible if !LCR_EFR_ENABLE. Read access also 209 * requires ACR[6]. 210 */ 211#define com_icr 5 /* index control register (R/W) */ 212#define REG_ICR com_icr 213 214/* 215 * 16950 register #7. It is the same as com_scr except it has a different 216 * abbreviation in the manufacturer's data sheet and it also serves as an 217 * index into the Indexed Control register set. 218 */ 219#define com_spr com_scr /* scratch pad (and index) register (R/W) */ 220#define REG_SPR com_scr 221 222/* 223 * 16950 indexed control registers #[0-0x13]. Access is via index in SPR, 224 * data in ICR (if ICR is accessible). 225 */ 226 227#define com_acr 0 /* additional control register (R/W) */ 228#define REG_ACR com_acr 229#define ACR_ASE 0x80 /* ASR/RFL/TFL enable */ 230#define ACR_ICRE 0x40 /* ICR enable */ 231#define ACR_TLE 0x20 /* TTL/RTL enable */ 232 233#define com_cpr 1 /* clock prescaler register (R/W) */ 234#define com_tcr 2 /* times clock register (R/W) */ 235#define com_ttl 4 /* transmitter trigger level (R/W) */ 236#define com_rtl 5 /* receiver trigger level (R/W) */ 237/* ... */ 238 239/* Hardware extension mode register for RSB-2000/3000. */ 240#define com_emr com_msr 241#define EMR_EXBUFF 0x04 242#define EMR_CTSFLW 0x08 243#define EMR_DSRFLW 0x10 244#define EMR_RTSFLW 0x20 245#define EMR_DTRFLW 0x40 246#define EMR_EFMODE 0x80 247