1/*-
2 * SPDX-License-Identifier: BSD-2-Clause
3 *
4 * Copyright (c) 2013 Adrian Chadd <adrian@FreeBSD.org>
5 * All rights reserved.
6 *
7 * Redistribution and use in source and binary forms, with or without
8 * modification, are permitted provided that the following conditions
9 * are met:
10 * 1. Redistributions of source code must retain the above copyright
11 *    notice, this list of conditions and the following disclaimer,
12 *    without modification.
13 * 2. Redistributions in binary form must reproduce at minimum a disclaimer
14 *    similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any
15 *    redistribution must be conditioned upon including a substantially
16 *    similar Disclaimer requirement for further binary redistribution.
17 *
18 * NO WARRANTY
19 * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
20 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
21 * LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY
22 * AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
23 * THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,
24 * OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
25 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
26 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER
27 * IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
28 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
29 * THE POSSIBILITY OF SUCH DAMAGES.
30 */
31#include <sys/cdefs.h>
32/*
33 * Implement some basic spectral scan control logic.
34 */
35#include "opt_ath.h"
36#include "opt_inet.h"
37#include "opt_wlan.h"
38
39#include <sys/param.h>
40#include <sys/systm.h>
41#include <sys/sysctl.h>
42#include <sys/kernel.h>
43#include <sys/lock.h>
44#include <sys/malloc.h>
45#include <sys/mutex.h>
46#include <sys/errno.h>
47
48#include <machine/bus.h>
49#include <machine/resource.h>
50#include <sys/bus.h>
51
52#include <sys/socket.h>
53
54#include <net/if.h>
55#include <net/if_var.h>
56#include <net/if_media.h>
57#include <net/if_arp.h>
58#include <net/ethernet.h>		/* XXX for ether_sprintf */
59
60#include <net80211/ieee80211_var.h>
61
62#include <net/bpf.h>
63
64#ifdef INET
65#include <netinet/in.h>
66#include <netinet/if_ether.h>
67#endif
68
69#include <dev/ath/if_athvar.h>
70#include <dev/ath/if_ath_spectral.h>
71#include <dev/ath/if_ath_misc.h>
72
73#include <dev/ath/ath_hal/ah_desc.h>
74
75struct ath_spectral_state {
76	HAL_SPECTRAL_PARAM	spectral_state;
77
78	/*
79	 * Should we enable spectral scan upon
80	 * each network interface reset/change?
81	 *
82	 * This is intended to allow spectral scan
83	 * frame reporting during channel scans.
84	 *
85	 * Later on it can morph into a larger
86	 * scale config method where it pushes
87	 * a "channel scan" config into the hardware
88	 * rather than just the spectral_state
89	 * config.
90	 */
91	int spectral_enable_after_reset;
92};
93
94/*
95 * Methods which are required
96 */
97
98/*
99 * Attach spectral to the given interface
100 */
101int
102ath_spectral_attach(struct ath_softc *sc)
103{
104	struct ath_spectral_state *ss;
105
106	/*
107	 * If spectral isn't supported, don't error - just
108	 * quietly complete.
109	 */
110	if (! ath_hal_spectral_supported(sc->sc_ah))
111		return (0);
112
113	ss = malloc(sizeof(struct ath_spectral_state),
114	    M_TEMP, M_WAITOK | M_ZERO);
115
116	if (ss == NULL) {
117		device_printf(sc->sc_dev, "%s: failed to alloc memory\n",
118		    __func__);
119		return (-ENOMEM);
120	}
121
122	sc->sc_spectral = ss;
123
124	(void) ath_hal_spectral_get_config(sc->sc_ah, &ss->spectral_state);
125
126	return (0);
127}
128
129/*
130 * Detach spectral from the given interface
131 */
132int
133ath_spectral_detach(struct ath_softc *sc)
134{
135
136	if (! ath_hal_spectral_supported(sc->sc_ah))
137		return (0);
138
139	if (sc->sc_spectral != NULL) {
140		free(sc->sc_spectral, M_TEMP);
141	}
142	return (0);
143}
144
145/*
146 * Check whether spectral needs enabling and if so,
147 * flip it on.
148 */
149int
150ath_spectral_enable(struct ath_softc *sc, struct ieee80211_channel *ch)
151{
152	struct ath_spectral_state *ss = sc->sc_spectral;
153
154	/* Default to disable spectral PHY reporting */
155	sc->sc_dospectral = 0;
156
157	if (ss == NULL)
158		return (0);
159
160	if (ss->spectral_enable_after_reset) {
161		ath_hal_spectral_configure(sc->sc_ah,
162		    &ss->spectral_state);
163		(void) ath_hal_spectral_start(sc->sc_ah);
164		sc->sc_dospectral = 1;
165	}
166	return (0);
167}
168
169/*
170 * Handle ioctl requests from the diagnostic interface.
171 *
172 * The initial part of this code resembles ath_ioctl_diag();
173 * it's likely a good idea to reduce duplication between
174 * these two routines.
175 */
176int
177ath_ioctl_spectral(struct ath_softc *sc, struct ath_diag *ad)
178{
179	unsigned int id = ad->ad_id & ATH_DIAG_ID;
180	void *indata = NULL;
181	void *outdata = NULL;
182	u_int32_t insize = ad->ad_in_size;
183	u_int32_t outsize = ad->ad_out_size;
184	int error = 0;
185	HAL_SPECTRAL_PARAM peout;
186	HAL_SPECTRAL_PARAM *pe;
187	struct ath_spectral_state *ss = sc->sc_spectral;
188	int val;
189
190	if (! ath_hal_spectral_supported(sc->sc_ah))
191		return (EINVAL);
192
193	ATH_LOCK(sc);
194	ath_power_set_power_state(sc, HAL_PM_AWAKE);
195	ATH_UNLOCK(sc);
196
197	if (ad->ad_id & ATH_DIAG_IN) {
198		/*
199		 * Copy in data.
200		 */
201		indata = malloc(insize, M_TEMP, M_NOWAIT);
202		if (indata == NULL) {
203			error = ENOMEM;
204			goto bad;
205		}
206		error = copyin(ad->ad_in_data, indata, insize);
207		if (error)
208			goto bad;
209	}
210	if (ad->ad_id & ATH_DIAG_DYN) {
211		/*
212		 * Allocate a buffer for the results (otherwise the HAL
213		 * returns a pointer to a buffer where we can read the
214		 * results).  Note that we depend on the HAL leaving this
215		 * pointer for us to use below in reclaiming the buffer;
216		 * may want to be more defensive.
217		 */
218		outdata = malloc(outsize, M_TEMP, M_NOWAIT | M_ZERO);
219		if (outdata == NULL) {
220			error = ENOMEM;
221			goto bad;
222		}
223	}
224	switch (id) {
225		case SPECTRAL_CONTROL_GET_PARAMS:
226			memset(&peout, 0, sizeof(peout));
227			outsize = sizeof(HAL_SPECTRAL_PARAM);
228			ath_hal_spectral_get_config(sc->sc_ah, &peout);
229			pe = (HAL_SPECTRAL_PARAM *) outdata;
230			memcpy(pe, &peout, sizeof(*pe));
231			break;
232		case SPECTRAL_CONTROL_SET_PARAMS:
233			if (insize < sizeof(HAL_SPECTRAL_PARAM)) {
234				error = EINVAL;
235				break;
236			}
237			pe = (HAL_SPECTRAL_PARAM *) indata;
238			ath_hal_spectral_configure(sc->sc_ah, pe);
239			/* Save a local copy of the updated parameters */
240			ath_hal_spectral_get_config(sc->sc_ah,
241			    &ss->spectral_state);
242			break;
243		case SPECTRAL_CONTROL_START:
244			ath_hal_spectral_configure(sc->sc_ah,
245			    &ss->spectral_state);
246			(void) ath_hal_spectral_start(sc->sc_ah);
247			sc->sc_dospectral = 1;
248			/* XXX need to update the PHY mask in the driver */
249			break;
250		case SPECTRAL_CONTROL_STOP:
251			(void) ath_hal_spectral_stop(sc->sc_ah);
252			sc->sc_dospectral = 0;
253			/* XXX need to update the PHY mask in the driver */
254			break;
255		case SPECTRAL_CONTROL_ENABLE_AT_RESET:
256			if (insize < sizeof(int)) {
257				device_printf(sc->sc_dev, "%d != %d\n",
258				    insize,
259				    (int) sizeof(int));
260				error = EINVAL;
261				break;
262			}
263			if (indata == NULL) {
264				device_printf(sc->sc_dev, "indata=NULL\n");
265				error = EINVAL;
266				break;
267			}
268			val = * ((int *) indata);
269			if (val == 0)
270				ss->spectral_enable_after_reset = 0;
271			else
272				ss->spectral_enable_after_reset = 1;
273			break;
274		case SPECTRAL_CONTROL_ENABLE:
275			/* XXX TODO */
276		case SPECTRAL_CONTROL_DISABLE:
277			/* XXX TODO */
278		break;
279		default:
280			error = EINVAL;
281			goto bad;
282	}
283	if (outsize < ad->ad_out_size)
284		ad->ad_out_size = outsize;
285	if (outdata && copyout(outdata, ad->ad_out_data, ad->ad_out_size))
286		error = EFAULT;
287bad:
288	if ((ad->ad_id & ATH_DIAG_IN) && indata != NULL)
289		free(indata, M_TEMP);
290	if ((ad->ad_id & ATH_DIAG_DYN) && outdata != NULL)
291		free(outdata, M_TEMP);
292	ATH_LOCK(sc);
293	ath_power_restore_power_state(sc);
294	ATH_UNLOCK(sc);
295
296	return (error);
297}
298