1#
2# Specific board setup for the Engenius ENH-200 802.11bgn mesh node.
3#
4# The Engenius ENH-200 has the following hardware:
5#
6# + AR7240 CPU SoC
7# + AR9285 Wifi
8# + Integrated switch
9# + 8MB flash
10# + 32MB RAM
11# + uboot environment
12
13# $FreeBSD$
14
15#NO_UNIVERSE
16
17include		"std.AR724X"
18ident		"ENH200"
19hints		"ENH200.hints"
20
21options 	AR71XX_REALMEM=32*1024*1024
22
23options 	AR71XX_ENV_UBOOT
24
25# For DOS - enable if required
26options 	MSDOSFS
27
28# uncompress - to boot read-only lzma natively from flash
29device		xz
30options 	GEOM_UZIP
31options 	ROOTDEVNAME=\"ufs:/dev/map/rootfs.uzip\"
32
33# Used for the static uboot partition map
34device          geom_map
35
36# Options needed for the EEPROM based calibration/PCI configuration data.
37options 	AR71XX_ATH_EEPROM	# Fetch EEPROM/PCI config from flash
38options 	ATH_EEPROM_FIRMWARE	# Use EEPROM from flash
39device		firmware		# Used by the above
40
41# Options required for miiproxy and mdiobus
42options 	ARGE_MDIO		# Export an MDIO bus separate from arge
43device		miiproxy		# MDIO bus <-> MII PHY rendezvous
44
45device		etherswitch
46device		arswitch
47