1# $FreeBSD$
2
3# USB ECHI 
4
5#
6# TI OMAP Power Management and System Companion Device sitting on the I2C bus
7# hint.tps65950.0.at="iicbus0"
8# hint.tps65950.0.addr=0xd0
9
10
11#
12# Defines the GPIO pin used to detect the Write Protect stat of the MMC/SD card.
13#hint.omap_mmc.0.wp_gpio="23"
14
15
16#
17# If 'phy_reset" is set, then the accompaning PHY is reset using one of the
18# GPIO pins. If the reset GPIO pin is not -1 then the pin will be toggled when
19# the USB driver is loaded.
20hint.ehci.0.phy_reset="0"
21
22#
23# Sets the PHY mode for the individual ports, the following values are allowed
24#   - EHCI_HCD_OMAP3_MODE_UNKNOWN   0
25#   - EHCI_HCD_OMAP3_MODE_PHY       1
26#   - EHCI_HCD_OMAP3_MODE_TLL       2
27hint.ehci.0.phy_mode_0="1"
28hint.ehci.0.phy_mode_1="0"
29hint.ehci.0.phy_mode_2="0"
30
31#
32# If specified the value indicates a pin that is toggled as a heart-beat. The
33# heart beat pusle is triggered every 500ms using the system tick timer.
34hint.omap_clk.0.heartbeat_gpio="150"
35
36
37#
38# Padconf (pinmux) settings - typically this would be set by the boot-loader
39# but can be overridden here.  These hints are applied to the H/W when the
40# SCM module is initialised.
41#
42# The format is:
43#     hint.omap_scm.0.padconf.<padname>=<muxmode:options>
44#
45# Where the options can be one of the following:
46#     output, input, input_pullup, input_pulldown
47#
48
49# Setup the pin settings for the HS USB Host (PHY mode)
50hint.omap4.0.padconf.ag19="usbb1_ulpiphy_stp:output"
51hint.omap4.0.padconf.ae18="usbb1_ulpiphy_clk:input_pulldown"
52hint.omap4.0.padconf.af19="usbb1_ulpiphy_dir:input_pulldown"
53hint.omap4.0.padconf.ae19="usbb1_ulpiphy_nxt:input_pulldown"
54hint.omap4.0.padconf.af18="usbb1_ulpiphy_dat0:input_pulldown"
55hint.omap4.0.padconf.ag18="usbb1_ulpiphy_dat1:input_pulldown"
56hint.omap4.0.padconf.ae17="usbb1_ulpiphy_dat2:input_pulldown"
57hint.omap4.0.padconf.af17="usbb1_ulpiphy_dat3:input_pulldown"
58hint.omap4.0.padconf.ah17="usbb1_ulpiphy_dat4:input_pulldown"
59hint.omap4.0.padconf.ae16="usbb1_ulpiphy_dat5:input_pulldown"
60hint.omap4.0.padconf.af16="usbb1_ulpiphy_dat6:input_pulldown"
61hint.omap4.0.padconf.ag16="usbb1_ulpiphy_dat7:input_pulldown"
62