1# $FreeBSD$
2
3# arge0 mdio bus
4hint.argemdio.0.at="nexus0"
5hint.argemdio.0.maddr=0x19000000
6hint.argemdio.0.msize=0x1000
7hint.argemdio.0.order=0
8
9# arge0: dedicated switch port
10hint.arge.0.phymask=0x10	# PHY4
11hint.arge.0.miimode=3		# RGMII
12hint.arge.0.mdio=mdioproxy1	# .. off of the switch mdiobus
13
14# arge1: nail to 1000/full, RGMII - connected to the switch
15hint.arge.1.media=1000		# Map to 1000/full
16hint.arge.1.fduplex=1		#
17hint.arge.1.phymask=0x0		# no directly mapped PHYs
18hint.arge.1.miimode=3		# RGMII
19
20hint.arswitch.0.at="mdio0"
21hint.arswitch.0.is_7240=0
22hint.arswitch.0.numphys=4
23hint.arswitch.0.phy4cpu=1
24hint.arswitch.0.is_rgmii=1
25hint.arswitch.0.is_gmii=0
26
27# Don't flip on anything that isn't already enabled.
28# This includes leaving the SPI CS1/CS2 pins as GPIO pins as they're
29# not used here.
30hint.gpio.0.function_set=0x00000000
31hint.gpio.0.function_clear=0x00000000
32
33# These are the GPIO LEDs and buttons which can be software controlled.
34hint.gpio.0.pinmask=0x000000ff
35
36# GPIO 0: Pin 1
37# GPIO 1: Pin 2
38# GPIO 2: RF LED
39# GPIO 3: Pin 3
40# GPIO 4: Pin 4
41# GPIO 5: Pin 5
42# GPIO 6: Pin 6
43# GPIO 7: Pin 7
44
45# RF led
46hint.gpioled.0.at="gpiobus0"
47hint.gpioled.0.name="rf"
48# pin 2
49hint.gpioled.0.pins=0x0004
50