1# 2# DIR-655A1 - 3x3 2GHz D-Link AP 3# 4# This contains a QCA9558 MIPS74k SoC with on-board 3x3 2GHz wifi, 5# 128MiB RAM, an AR8327 5-port gigabit ethernet switch. 6# 7# $FreeBSD: stable/11/sys/mips/conf/DIR-655A1 345344 2019-03-20 18:49:45Z kib $ 8# 9 10#NO_UNIVERSE 11 12# Include the default QCA955x parameters 13include "QCA955X_BASE" 14 15ident DIR-655A1 16 17# Override hints with board values 18hints "DIR-655A1.hints" 19 20# Force the board memory - the base AP135 has 128MB RAM 21options AR71XX_REALMEM=(128*1024*1024) 22 23# i2c GPIO bus 24#device gpioiic 25#device iicbb 26#device iicbus 27#device iic 28 29# Options required for miiproxy and mdiobus 30options ARGE_MDIO # Export an MDIO bus separate from arge 31device miiproxy # MDIO bus <-> MII PHY rendezvous 32 33device etherswitch 34device arswitch 35 36# read MSDOS formatted disks - USB 37#options MSDOSFS 38 39# Enable the uboot environment stuff rather then the 40# redboot stuff. 41options AR71XX_ENV_UBOOT 42 43# uzip - to boot natively from flash 44device xz 45options GEOM_UZIP 46 47# Used for the static uboot partition map 48device geom_map 49 50options AR71XX_ATH_EEPROM 51device firmware # Used by the above 52options ATH_EEPROM_FIRMWARE 53 54# Boot off of the rootfs, as defined in the geom_map setup. 55options ROOTDEVNAME=\"ufs:map/rootfs.uzip\" 56 57# Default to accept 58options IPFIREWALL_DEFAULT_TO_ACCEPT 59