1# 2# Specific board setup for the Atheros AP91 reference board. 3# 4# The AP93 has the following hardware: 5# 6# + AR7240 CPU SoC 7# + AR9280 Wifi 8# + Integrated switch (XXX speed?) 9# + 16MB flash 10# + 64MB RAM 11# + uboot environment 12 13# $FreeBSD: stable/11/sys/mips/conf/AP93 345344 2019-03-20 18:49:45Z kib $ 14 15#NO_UNIVERSE 16 17include "AR724X_BASE" 18ident "AP93" 19hints "AP93.hints" 20 21options AR71XX_REALMEM=64*1024*1024 22 23options AR71XX_ENV_UBOOT 24 25# For DOS - enable if required 26options MSDOSFS 27 28# uncompress - to boot read-only lzma natively from flash 29device xz 30options GEOM_UZIP 31options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uzip\" 32 33# Used for the static uboot partition map 34device geom_map 35 36# Options needed for the EEPROM based calibration/PCI configuration data. 37options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash 38options ATH_EEPROM_FIRMWARE # Use EEPROM from flash 39device firmware # Used by the above 40 41# Options required for miiproxy and mdiobus 42options ARGE_MDIO # Export an MDIO bus separate from arge 43device miiproxy # MDIO bus <-> MII PHY rendezvous 44 45device etherswitch 46device arswitch 47