1# 2# $FreeBSD: releng/10.2/sys/mips/conf/AR71XX_BASE.hints 228944 2011-12-29 05:51:48Z adrian $ 3# 4hint.apb.0.at="nexus0" 5hint.apb.0.irq=4 6 7# uart0 8hint.uart.0.at="apb0" 9# see atheros/uart_cpu_ar71xx.c why +3 10hint.uart.0.maddr=0x18020003 11hint.uart.0.msize=0x18 12hint.uart.0.irq=3 13 14#ohci 15hint.ohci.0.at="apb0" 16hint.ohci.0.maddr=0x1c000000 17hint.ohci.0.msize=0x01000000 18hint.ohci.0.irq=6 19 20#ehci 21hint.ehci.0.at="nexus0" 22hint.ehci.0.maddr=0x1b000000 23hint.ehci.0.msize=0x01000000 24hint.ehci.0.irq=1 25 26# pci 27hint.pcib.0.at="nexus0" 28hint.pcib.0.irq=0 29 30hint.arge.0.at="nexus0" 31hint.arge.0.maddr=0x19000000 32hint.arge.0.msize=0x1000 33hint.arge.0.irq=2 34 35# phymask, media and fduplex depend upon the specific 36# board. 37# So each board will override the settings as needed. 38 39hint.arge.1.at="nexus0" 40hint.arge.1.maddr=0x1a000000 41hint.arge.1.msize=0x1000 42hint.arge.1.irq=3 43 44# SPI flash 45hint.spi.0.at="nexus0" 46hint.spi.0.maddr=0x1f000000 47hint.spi.0.msize=0x10 48 49hint.mx25l.0.at="spibus0" 50hint.mx25l.0.cs=0 51 52# Watchdog 53hint.ar71xx_wdog.0.at="nexus0" 54 55# GPIO 56hint.gpio.0.at="apb0" 57hint.gpio.0.maddr=0x18040000 58hint.gpio.0.msize=0x1000 59hint.gpio.0.irq=2 60 61# Each board should override the GPIO bus pins with the configuration 62# relevant to it. Thus no pins are defined here. 63 64# hwpmc device 65hint.ar71xx_pmc.0.at="apb0" 66hint.ar71xx_pmc.0.irq=5 67