1#
2# Specific board setup for the Engenius ENH-200 802.11bgn mesh node.
3#
4# The Engenius ENH-200 has the following hardware:
5#
6# + AR7240 CPU SoC
7# + AR9285 Wifi
8# + Integrated switch
9# + 8MB flash
10# + 32MB RAM
11# + uboot environment
12
13# $FreeBSD$
14
15include		"AR724X_BASE"
16ident		"ENH200"
17hints		"ENH200.hints"
18
19options		AR71XX_REALMEM=32*1024*1024
20
21options		AR71XX_ENV_UBOOT
22
23# For DOS - enable if required
24options 	MSDOSFS
25
26# uncompress - to boot read-only lzma natively from flash
27device		geom_uncompress
28options		GEOM_UNCOMPRESS
29options		ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"
30
31# Used for the static uboot partition map
32device          geom_map
33
34# Options needed for the EEPROM based calibration/PCI configuration data.
35options 	AR71XX_ATH_EEPROM	# Fetch EEPROM/PCI config from flash
36options 	ATH_EEPROM_FIRMWARE	# Use EEPROM from flash
37device		firmware		# Used by the above
38
39# Options required for miiproxy and mdiobus
40options 	ARGE_MDIO		# Export an MDIO bus separate from arge
41device		miiproxy		# MDIO bus <-> MII PHY rendezvous
42
43device		etherswitch
44device		arswitch
45