1# This file (and the kernel config file accompanying it) are not designed 2# to be used by themselves. Instead, users of this file should create a 3# kernel # config file which includes this file (which gets the basic hints), 4# then override the default options (adding devices as needed) and adding 5# hints as needed (for example, the GPIO and LAN PHY.) 6 7# $FreeBSD$ 8 9hint.apb.0.at="nexus0" 10hint.apb.0.irq=4 11 12# uart0 13hint.uart.0.at="apb0" 14# NB: This isn't an ns8250 UART 15hint.uart.0.maddr=0x18020000 16hint.uart.0.msize=0x18 17hint.uart.0.irq=3 18 19#ehci - note the 0x100 offset for the AR913x/AR724x 20hint.ehci.0.at="nexus0" 21hint.ehci.0.maddr=0x1b000100 22hint.ehci.0.msize=0x00ffff00 23hint.ehci.0.irq=1 24 25hint.arge.0.at="nexus0" 26hint.arge.0.maddr=0x19000000 27hint.arge.0.msize=0x1000 28hint.arge.0.irq=2 29 30hint.arge.1.at="nexus0" 31hint.arge.1.maddr=0x1a000000 32hint.arge.1.msize=0x1000 33hint.arge.1.irq=3 34 35# XXX The ath device hangs off of the AHB, rather than the Nexus. 36hint.ath.0.at="nexus0" 37hint.ath.0.maddr=0x18100000 38hint.ath.0.msize=0x20000 39hint.ath.0.irq=0 40hint.ath.0.vendor_id=0x168c 41hint.ath.0.device_id=0x0035 42# Set this to define where the ath calibration data 43# should be fetched from in physical memory. 44# hint.ath.0.eepromaddr=0x1fff1000 45 46# SPI flash 47hint.spi.0.at="nexus0" 48hint.spi.0.maddr=0x1f000000 49hint.spi.0.msize=0x10 50 51hint.mx25l.0.at="spibus0" 52hint.mx25l.0.cs=0 53 54# Watchdog 55hint.ar71xx_wdog.0.at="nexus0" 56 57# The GPIO function and pin mask is configured per-board 58hint.gpio.0.at="apb0" 59hint.gpio.0.maddr=0x18040000 60hint.gpio.0.msize=0x1000 61hint.gpio.0.irq=2 62