1Version 0.1.1 2 - Added support for SWC-E100. 3 - Added support for Mezon (www.mezon.lt) version of SWC-U200. You 4 have to select the SSID from the command line at the moment, but 5 this will be handled somewhat better in the future. 6 - Updated udev rules to start madwimax by default when device is 7 plugged. 8 - Added madwimax manual page. 9 - Change the default installation path of madwimax config files from 10 $prefix/etc to $prefix/etc/madwimax. 11 - Added several new options. 12 - Lots of bugs fixed. 13 - Cleaned up some pieces of code. 14 15Version 0.1.0 16 - Added a table of supported devices (fixes inability to connect to 17 the devices with BL22 firmware out of the box). 18 - Also device mathcing can now be controlled by the command-line options 19 (namely --device and --exact-device). See the help. 20 - Added an option to detach pseudo-DVD kernel driver by the driver 21 itself (so it works without udev/sysfs). 22 - Now autotools are used for build system. 23 - The driver can run user-supplied scripts on network connect/disconnect. 24 - TAP interface mtu is set to 1386 at startup. 25 - Can now log to the specified file/syslog (when daemonized). 26 - Allocated network interface is called wimaxN instead of tapN. 27 - Various fixes and enhancements. 28 29Version 0.0.2 30 - Fixed reconnection issue. The driver was not able to repair a failed 31 connection at all. 32 - Fixed some rare startup problems. The driver now flushes the garbage 33 from the previous session. 34 - Added command-line options parsing. 35 - Added support for diode control. 36 - Added an option to daemonize the driver. 37 - The driver now brings the TAP interface up when the device connects 38 to the network and down when the connection is lost. 39 - The driver immediately exits when it founds device unplugged so now 40 it can be safely started by udev when device is plugged. 41 - Various minor fixes. 42 - Cleaned up code. 43 44Version 0.0.1 45 - Initial networking support. 46