1/* 2 * setup.c - boot time setup code 3 */ 4 5#include <linux/init.h> 6 7#include <asm/bootinfo.h> 8#include <asm/reboot.h> 9#include <asm/time.h> 10#include <linux/ioport.h> 11 12#include <asm/mach-rc32434/rb.h> 13#include <asm/mach-rc32434/pci.h> 14 15struct pci_reg __iomem *pci_reg; 16EXPORT_SYMBOL(pci_reg); 17 18static struct resource pci0_res[] = { 19 { 20 .name = "pci_reg0", 21 .start = PCI0_BASE_ADDR, 22 .end = PCI0_BASE_ADDR + sizeof(struct pci_reg), 23 .flags = IORESOURCE_MEM, 24 } 25}; 26 27static void rb_machine_restart(char *command) 28{ 29 /* just jump to the reset vector */ 30 writel(0x80000001, IDT434_REG_BASE + RST); 31 ((void (*)(void)) KSEG1ADDR(0x1FC00000u))(); 32} 33 34static void rb_machine_halt(void) 35{ 36 for (;;) 37 continue; 38} 39 40void __init plat_mem_setup(void) 41{ 42 u32 val; 43 44 _machine_restart = rb_machine_restart; 45 _machine_halt = rb_machine_halt; 46 pm_power_off = rb_machine_halt; 47 48 set_io_port_base(KSEG1); 49 50 pci_reg = ioremap_nocache(pci0_res[0].start, 51 pci0_res[0].end - pci0_res[0].start); 52 if (!pci_reg) { 53 printk(KERN_ERR "Could not remap PCI registers\n"); 54 return; 55 } 56 57 val = __raw_readl(&pci_reg->pcic); 58 val &= 0xFFFFFF7; 59 __raw_writel(val, (void *)&pci_reg->pcic); 60 61#ifdef CONFIG_PCI 62 /* Enable PCI interrupts in EPLD Mask register */ 63 *epld_mask = 0x0; 64 *(epld_mask + 1) = 0x0; 65#endif 66 write_c0_wired(0); 67} 68 69const char *get_system_type(void) 70{ 71 switch (mips_machtype) { 72 case MACH_MIKROTIK_RB532A: 73 return "Mikrotik RB532A"; 74 break; 75 default: 76 return "Mikrotik RB532"; 77 break; 78 } 79} 80