1# BCM94704agr board as l2 switch 2# Copyright 2006, Broadcom Corporation 3# All Rights Reserved. 4# 5# This is UNPUBLISHED PROPRIETARY SOURCE CODE of Broadcom Corporation; 6# the contents of this file may not be disclosed to third parties, copied 7# or duplicated in any form, in whole or in part, without the prior 8# written permission of Broadcom Corporation. 9# $Id: bcm94704agr-sw.txt,v 1.1.1.1 2008/10/15 03:25:52 james26_jang Exp $ 10boardtype=0x042f 11boardnum=${serno} 12# Board revision 1.0 13boardrev=0x10 14# BCM5325 RoboSwitch requires reverse MII initialization 15boardflags=0x10 16 17# MIPS clock frequency in MHz 18clkfreq=264 19 20# 64 MB DDR SDRAM (4 Meg x 16 x 2) 21sdram_init=0x0009 22sdram_config=0x0062 23sdram_refresh=0x0000 24sdram_ncdl=0 25 26# BCM5325 27et0macaddr=00:90:4c:4e:${maclo} 28et0phyaddr=30 29et0mdcport=0 30 31# AC101L 32et1macaddr=00:90:4c:4f:${maclo} 33et1phyaddr=5 34et1mdcport=1 35 36# PMON variables 37dl_ram_addr=a0001000 38os_ram_addr=80001000 39os_flash_addr=bfc40000 40lan_ipaddr=192.168.1.1 41lan_netmask=255.255.255.0 42scratch=a0180000 43boot_wait=on 44 45# Watchdog timer in ms 46watchdog=3000 47 48# Reset 49reset_gpio=7 50 51# glue between bootloader and firmware 52landevs=et0 et1 wl0 wl1 53wandevs= 54