1# BCM94702AP board with BCM5325E 2# Copyright 2006, Broadcom Corporation 3# All Rights Reserved. 4# 5# THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY 6# KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM 7# SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS 8# FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE. 9# $Id: bcm94702ap-5325e.txt,v 1.1.1.1 2008/10/15 03:25:52 james26_jang Exp $ 10boardflags=0x0110 11boardnum=${serno} 12 13# 4702 CPU clock frequency in Mhz 14# Only valid value is 125, anything else defaults to 100Mhz 15clkfreq=125 16 17# 4702 SDRAM controller parameters 18sdram_init=0x0419 19sdram_config=0x0000 20sdram_refresh=0x8040 21sdram_ncdl=0 22 23# 4702 MAC and PHY parameters 24et0macaddr=00:90:4c:49:${maclo} 25et0phyaddr=30 26et0mdcport=0 27et1macaddr=00:90:4c:4a:${maclo} 28et1phyaddr=5 29et1mdcport=1 30 31# PMON variables 32dl_ram_addr=a0001000 33os_ram_addr=80001000 34os_flash_addr=bfc40000 35lan_ipaddr=192.168.1.1 36lan_netmask=255.255.255.0 37scratch=a0180000 38boot_wait=on 39 40# watchdog set to 3 sec 41watchdog=3000 42 43# GPIO mapping 44gpio6=robo_reset 45 46# Robo switch config (vlan0:LAN, vlan1:WAN) 47vlan0hwname=et0 48vlan0ports=1 2 3 4 5* 49vlan1hwname=et0 50vlan1ports=0 5u 51 52# Bootloader and OS glue 53landevs=vlan0 wl0 wl1 54wandevs=et0 55 56