# BCM94702AP board with BCM5325E
# Copyright 2006, Broadcom Corporation
# All Rights Reserved.
# 
# THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY
# KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM
# SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS
# FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE.
# $Id: bcm94702ap-5325e.txt,v 1.1.1.1 2008/10/15 03:25:52 james26_jang Exp $
boardflags=0x0110
boardnum=${serno}

# 4702 CPU clock frequency in Mhz
# Only valid value is 125, anything else defaults to 100Mhz
clkfreq=125

# 4702 SDRAM controller parameters
sdram_init=0x0419
sdram_config=0x0000
sdram_refresh=0x8040
sdram_ncdl=0

# 4702 MAC and PHY parameters
et0macaddr=00:90:4c:49:${maclo}
et0phyaddr=30
et0mdcport=0
et1macaddr=00:90:4c:4a:${maclo}
et1phyaddr=5
et1mdcport=1

# PMON variables
dl_ram_addr=a0001000
os_ram_addr=80001000
os_flash_addr=bfc40000
lan_ipaddr=192.168.1.1
lan_netmask=255.255.255.0
scratch=a0180000
boot_wait=on

# watchdog set to 3 sec
watchdog=3000

# GPIO mapping
gpio6=robo_reset

# Robo switch config (vlan0:LAN, vlan1:WAN)
vlan0hwname=et0
vlan0ports=1 2 3 4 5*
vlan1hwname=et0
vlan1ports=0 5u

# Bootloader and OS glue
landevs=vlan0 wl0 wl1
wandevs=et0