/linux-master/arch/m68k/math-emu/ |
H A D | fp_decode.h | 21 * required INSTEAD OF the above restrictions. (This clause is 50 * is destroyed during decoding 113 | it depends on the instr which of the modes is valid 196 | test if %pc is the base register for the indirect addr mode 202 | test if %pc is the base register for one of the extended modes
|
/linux-master/arch/arm/mach-tegra/ |
H A D | sleep-tegra20.S | 102 * r0 is cpu to reset 193 * IRAM when this code is executed; immediately switch to CLKM and 215 ldr r7, [r2, r5] @ r7 is the addr in the pad_address 234 mov32 r4, ((1 << 28) | (4)) @ burst policy is PLLP 323 * executes from IRAM with SDRAM in selfrefresh when target state is LP0 or LP1 324 * executes from SDRAM with target state is LP2 379 ldr r0, [r2, r5] @ r0 is the addr in the pad_address
|
/linux-master/arch/sh/kernel/cpu/sh3/ |
H A D | entry.S | 20 ! to be jumped is too far, but it causes illegal slot exception. 38 * if the order here is changed, it needs to be 475 cmp/hs r5, r4 ! is it a valid IRQ? 481 * path and special case the event dispatch instead. This is the 484 * but is unfortunately reported through INTEVT rather than
|
/linux-master/drivers/pinctrl/intel/ |
H A D | pinctrl-intel.c | 216 * @PAD_UNLOCKED: pad is fully controlled by the configuration registers 218 * @PAD_LOCKED_TX: pad configuration TX state is locked 221 * Locking is considered as read-only mode for corresponding registers and 222 * their respective fields. That said, TX state bit is locked separately from 254 * the pad is considered unlocked. Any other case means that it is 496 * If pin is already configured in GPIO mode, we assume that 689 case 1: /* Set default strength value in case none is given */ 716 case 1: /* Set default strength value in case none is given */ 847 * @community: Community is fille 1026 void __iomem *is; local 1035 writel(BIT(gpp_offset), is); local 1049 void __iomem *reg, *is; local 1061 writel(BIT(gpp_offset), is); local 1185 void __iomem *reg, *is; local 1231 void __iomem *reg, *is; local [all...] |
/linux-master/tools/testing/selftests/mm/ |
H A D | charge_reserved_hugetlb.sh | 4 # Kselftest framework requirement - SKIP code is 4. 179 echo expect_failure is "$expect_failure" 203 echo ================= write_hugetlb_memory.sh output is: 217 echo write_result is $write_result 306 expect_equal "0" "$final_hugetlb" "final hugetlb is not zero" 307 expect_equal "0" "$final_reservation" "final reservation is not zero" 386 "hugetlbt_cgroup_test1 final hugetlb is not zero" 388 "hugetlbt_cgroup_test1 final reservation is not zero" 394 "hugetlb_cgroup_test2 final hugetlb is not zero" 396 "hugetlb_cgroup_test2 final reservation is no [all...] |
/linux-master/drivers/atm/ |
H A D | nicstar.h | 100 * BUF_NONE is only used by the driver. 272 case, the value of the first word is all zeroes. */ 368 - When the opcode is FIXED, sramad specifies the SRAM address of the 370 - When the opcode is END, sramad specifies the SRAM address of the 580 #error NS_SMBUFSIZE is incorrect in nicstar.h 592 #error NS_LGBUFSIZE is incorrect in nicstar.h 602 #error NS_RSQSIZE is incorrect in nicstar.h 614 #error NS_VPIBITS is incorrect in nicstar.h 693 /* NOTE: for small and large buffer pools, the count is not used, as the 694 actual value used for buffer management is th [all...] |
/linux-master/arch/sh/boot/compressed/ |
H A D | head_32.S | 123 .word 0x8000 ! size to move, when setup is not
|
/linux-master/arch/arm/include/asm/ |
H A D | ecard.h | 7 * This is a new system as from Linux 1.2.3 100 unsigned char is:1; /* Interrupt status pointers */ member in struct:in_ecid
|
H A D | cmpxchg.h | 11 * On the StrongARM, "swp" is terminally broken since it bypasses the 13 * since we use normal loads/stores as well, this is really bad. 19 * We choose (1) since its the "easiest" to achieve here and is not 78 #error SMP is not supported on this platform 110 /* Cause a link-time error, the xchg() size is not supported */ 129 #error "SMP is not supported on this platform"
|
/linux-master/arch/m68k/fpsp040/ |
H A D | x_unimp.S | 71 bnes no_store |if STORE_FLG is set, no store
|
/linux-master/tools/perf/scripts/perl/Perf-Trace-Util/lib/Perf/Trace/ |
H A D | Core.pm | 184 This library is free software; you can redistribute it and/or modify
|
/linux-master/arch/s390/kernel/syscalls/ |
H A D | syscalltbl | 93 * This file is meant to be included from entry.S.
|
/linux-master/arch/sh/kernel/ |
H A D | entry-common.S | 9 ! to be jumped is too far, but it causes illegal slot exception. 27 * if the order here is changed, it needs to be 214 * Note: This assumes that the trapa value is left in its original 251 * given cpu model may be used, but the unified trap number 0x1f is 366 ! Yes it is traced.
|
/linux-master/drivers/scsi/arm/ |
H A D | fas216.c | 12 * This is a generic driver. To use it, have a look at cumana_2.c. You 61 * the data sheet. This restriction is crazy, especially when 68 * > (1) Re-negotiation at every selection is not recommended, since a 69 * > significant performance impact is likely. 72 * > RESET message is received, until a hard reset condition occurs, or until one 74 * > transfer mode is asynchronous data transfer mode. The default data transfer 75 * > mode is entered at power on, after a BUS DEVICE RESET message, or after a hard 158 unsigned char is, stat, inst; local 160 is = fas216_readb(info, REG_IS); 168 fas216_readb(info, REG_CMD), stat, inst, is, 1354 fas216_busservice_intr(FAS216_Info *info, unsigned int stat, unsigned int is) argument 1555 fas216_funcdone_intr(FAS216_Info *info, unsigned int stat, unsigned int is) argument 1638 unsigned char inst, is, stat; local [all...] |
/linux-master/arch/x86/crypto/ |
H A D | ghash-clmulni-intel_asm.S | 63 pxor T2, T1 # <T1:DATA> is result of
|
/linux-master/arch/m68k/ifpsp060/ |
H A D | os.S | 9 |THE SOFTWARE is provided on an "AS IS" basis and without warranty. 24 |so long as this entire notice is retained without alteration in any modified and/or 57 | Each IO routine checks to see if the memory write/read is to/from user 65 | The result is that Unix processes are allowed to sleep as a consequence 353 | This is the exit point for the 060FPSP when an instruction is being traced 366 | This is the exit point for the 060FPSP when an access error exception 367 | is encountered. The routine below should point to the operating system 368 | handler for access error exceptions. The exception stack frame is an 372 | is mos [all...] |
/linux-master/arch/arm64/net/ |
H A D | bpf_jit.h | 125 * ST{ADD,CLR,SET,EOR} is simply encoded as an alias for 177 #define A64_SBFM(sf, Rd, Rn, ir, is) A64_BITFIELD(sf, Rd, Rn, ir, is, SIGNED) 179 #define A64_UBFM(sf, Rd, Rn, ir, is) A64_BITFIELD(sf, Rd, Rn, ir, is, UNSIGNED) 205 * Rd |= imm16 << shift (where shift is {0, 16, 32, 48});
|
/linux-master/arch/arc/ |
H A D | Makefile | 25 # (probably the compiler is too old). Use ISA default mcpu flag instead as a safe option. 26 $(warning ** WARNING ** CONFIG_ARC_TUNE_MCPU flag '$(tune-mcpu)' is unknown, fallback to '$(tune-mcpu-def-y)') 67 # small data is default for elf32 tool-chain. If not usable, disable it 110 @$(kecho) ' Image $(boot)/uImage is ready'
|
/linux-master/arch/alpha/lib/ |
H A D | strchr.S | 7 * string, or null if it is not found. 33 cmpbge zero, t4, t4 # .. e1 : bits set iff byte is garbage
|
H A D | ev67-strchr.S | 7 * string, or null if it is not found. 50 cmpbge zero, t4, t4 # E : bits set iff byte is garbage 52 /* This quad is _very_ serialized. Lots of stalling happens */ 64 * Yuk. This loop is going to stall like crazy waiting for the 66 * unrolled multiple times - is that safe to do in kernel space?
|
/linux-master/arch/mips/lib/ |
H A D | memcpy.S | 2 * This file is subject to the terms and conditions of the GNU General Public 50 * - src is readable 51 * - dst is writable 56 * __copy_user assumes that src and dst don't overlap, and that the call is 59 * - src is readable (no exceptions when reading src) 61 * - dst is writable (no exceptions when writing dst) 66 # ensure that all of the destination buffer is overwritten to prevent 82 * (1) is set up up by uaccess.h and maintained by not writing AT in copy_user 83 * (2) is met by incrementing src by the number of bytes copied 84 * (3) is me [all...] |
/linux-master/arch/s390/kernel/vdso64/ |
H A D | Makefile | 27 KBUILD_CFLAGS_64 := $(filter-out -mno-pic-data-is-text-relative,$(KBUILD_CFLAGS_64)) 46 # Force dependency (incbin is bad)
|
/linux-master/tools/testing/ktest/ |
H A D | ktest.pl | 74 # value something that is common. 240 # set when a test is something other that just building or install 244 # tell build not to worry about warnings, even when WARNINGS_FILE is set 254 # force_config is the list of configs that we force enabled (or disabled) 392 For build only tests, it is still needed to differentiate log files. 396 The box is expected to have ssh on normal bootup, provide the user 402 You can use \${PWD} that will be the path where ktest.pl is run, or use 403 \${THIS_DIR} which is assigned \${PWD} but may be changed later. 409 You can use \${PWD} that will be the path where ktest.pl is run, or use 410 \${THIS_DIR} which is assigne [all...] |
/linux-master/drivers/usb/core/ |
H A D | hub.h | 50 #error event_bits[] is too short! 95 * @usb3_lpm_u1_permit: whether USB3 U1 LPM is permitted. 96 * @usb3_lpm_u2_permit: whether USB3 U2 LPM is permitted.
|
/linux-master/arch/m68k/ifpsp060/src/ |
H A D | isp.S | 9 THE SOFTWARE is provided on an "AS IS" basis and without warranty. 24 so long as this entire notice is retained without alteration in any modified and/or 30 # This file is appended to the top of the 060ISP package 377 # instructions may be executing while Trace is enabled. If so, then # 384 # If none of these occur, then a normal exit is made through # 486 btst &0x7,EXC_ISR(%a6) # is trace enabled? 514 tst.b EXC_ISR(%a6) # no; is trace enabled? 590 btst &0x7,EXC_ISR(%a6) # is trace mode on? 802 # this is the exit point if a data read or write fails. 821 # this is th [all...] |