/netgear-R7000-V1.0.7.12_1.2.5/src/router/iptables-1.4.12/src/include/linux/netfilter/ |
H A D | xt_physdev.h | 14 #define XT_PHYSDEV_OP_ISOUT 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/src/router/iptables-1.4.12/src/include/linux/netfilter_ipv6/ |
H A D | ip6t_rt.h | 23 #define IP6T_RT_FST 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/src/router/iptables-1.x/include/linux/netfilter_ipv6/ |
H A D | ip6t_frag.h | 16 #define IP6T_FRAG_MF 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/ap/gpl/tcpdump-4.4.0/ |
H A D | ieee802_11_radio.h | 263 #define IEEE80211_RADIOTAP_F_FCS 0x10 /* frame includes FCS */ 279 #define IEEE80211_RADIOTAP_MCS_FEC_TYPE_KNOWN 0x10 289 #define IEEE80211_RADIOTAP_MCS_FEC_LDPC 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/drivers/net/irda/ |
H A D | smsc-sio.h | 23 #define SMSCSIOFLAT_UART2MODE_VAL_ASKIR 0x10 61 #define LPC47N227_PARPORT2AUTOPWRDOWN_MASK 0x10 /* auto power down on if set */ 70 #define LPC47N227_UART2MODE_VAL_ASKIR 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/drivers/edac/ |
H A D | mv64x60_edac.h | 29 #define MV64x60_CPU_ERR_PARITY 0x10 /* 0x0138 */ 37 #define MV64X60_SRAM_ERR_ADDR_LO 0x10 /* 0x0390 */ 68 #define MV64X60_PCI_ERROR_CMD 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/drivers/i2c/busses/ |
H A D | i2c-parport.h | 62 .getsda = { 0x10, STAT, 0 }, 75 .getsda = { 0x10, STAT, 1 }, 83 .getsda = { 0x10, STAT, 1 },
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/arch/x86/include/asm/visws/ |
H A D | cobalt.h | 24 #define CO_CPU_CTRL 0x10 39 #define CO_APIC_HI(n) (((n) * 0x10) + 4) 40 #define CO_APIC_LO(n) ((n) * 0x10)
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/sound/oss/ |
H A D | waveartist.h | 19 #define DAT_RF 0x10 30 #define DAT_RFIE 0x10 41 #define WACMD_INPUTFORMAT 0x10 //0-8S, 1-16S, 2-8U
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/sound/pci/oxygen/ |
H A D | cs2000.h | 64 #define CS2000_REF_CLK_DIV_1 0x10 67 #define CS2000_CLK_OUT_UNL 0x10 75 #define CS2000_CLK_IN_BW_2 0x10
|
H A D | pcm1796.h | 18 #define PCM1796_FMT_20_RJUST 0x10 30 #define PCM1796_OPE 0x10 46 #define PCM1796_DFTH 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/sound/pcmcia/vx/ |
H A D | vxpocket.h | 60 #define VXP_CDSP_RESERVED_MASK 0x10 67 #define P24_CDSP_MIC20_SEL_MASK 0x10 83 #define VXP_DLG_RESERVED1_0_MASK 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/sound/soc/codecs/ |
H A D | wm2000.h | 47 #define WM2000_STATUS_CAT_GAIN_COMPLETE 0x10 57 #define WM2000_MODE_CAT_GAIN_ENABLE 0x10 70 #define WM2000_ANC_ENG_SET 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/include/linux/ |
H A D | serial_reg.h | 31 #define UART_IERX_SLEEP 0x10 /* Enable sleep mode */ 66 #define UART_FCR_T_TRIG_01 0x10 81 #define UART_FCR6_T_TRIGGER_8 0x10 /* Mask for transmit trigger set at 8 */ 94 #define UART_LCR_EPAR 0x10 /* Even parity select */ 107 #define UART_MCR_LOOP 0x10 /* Enable loopback test mode */ 116 #define UART_LSR_BI 0x10 /* Break interrupt indicator */ 127 #define UART_MSR_CTS 0x10 /* Clear to Send */ 149 #define UART_EFR_ECB 0x10 /* Enhanced control bit */ 180 #define UART_TRG_16 0x10 195 #define UART_FCTR_TRGB 0x10 /* T [all...] |
H A D | mc146818rtc.h | 77 # define RTC_REF_CLCK_1MHZ 0x10 90 # define RTC_UIE 0x10 /* update-finished interrupt enable */ 102 # define RTC_UF 0x10
|
H A D | sc26198.h | 138 #define MR0_TXHIGH 0x10 157 #define MR1_PARNONE 0x10 176 #define MR2_AUTOCTS 0x10 204 #define BRG_19200 0x10 261 #define SR_RXOVERRUN 0x10 276 #define IR_XONXOFF 0x10 290 #define IVR_RXDATA 0x10 315 #define BRGCTCR_1SCLK32 0x10 349 #define XISR_RXXONSENT 0x10 376 #define CIR_SUBADDR 0x10 [all...] |
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/include/pcmcia/ |
H A D | cisreg.h | 29 #define CISREG_IOBASE_3 0x10 61 #define PRR_WP_EVENT 0x10 76 #define ESR_REQ_ATTN 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/include/linux/mfd/pcf50633/ |
H A D | adc.h | 35 #define PCF50633_ADCC1_MUX_BATSNS_SUBTR 0x10 51 #define PCF50633_ADCC3_RES_DIV_TWO 0x10 55 #define PCF50633_ADCS3_REF_ACCSW 0x10
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/include/linux/mmc/ |
H A D | sdio.h | 112 #define SDIO_CCCR_CAP_S4MI 0x10 /* interrupt during 4-bit CMD53 */ 125 #define SDIO_CCCR_BLKSIZE 0x10 162 #define SDIO_FBR_BLKSIZE 0x10 /* block size (2 bytes) */
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/arch/blackfin/mach-bf518/include/mach/ |
H A D | defBF518.h | 43 #define ASEN 0x10 /* Auxiliary snapshot control */ 53 #define RXOVE 0x10 /* Receive overrun error interrupt enable */ 63 #define RXOV 0x10 /* Receive snapshot overrun status */
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/arch/arm/include/asm/ |
H A D | floppy.h | 58 { 0x10, 0x21, 0x23, 0x33 }, 59 { 0x10, 0x21, 0x23, 0x33 } 77 floppy_selects[0][0] = 0x10;
|
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/drivers/net/wan/ |
H A D | hd64572.h | 55 #define TTX_REG(reg, chan) (reg + 0x10*(2*chan + 1)) /* Timer Tx */ 114 #define TIMER0TX_OFFSET 0x10 211 #define DST_RBIT 0x10 /* Residual bit */ 226 #define ST_RX_RESBIT 0x10 /* Residual bit */ 281 #define MD0_AUTO_ENA 0x10 314 #define MD2_ADPLL_X32 0x10 326 #define CTL_IDLC 0x10 333 #define CTL_IDLE 0x10 359 #define EXS_TES0 0x10 405 #define ST1_SYN_FLAG 0x10 [all...] |
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/drivers/staging/xgifb/ |
H A D | XGI_main.h | 73 #define VM_CMD_QUEUE_CAP 0x10 101 #define VB_PART2_ADR (0x10-0x30) 192 #define XGI_SCRATCH_REG_1A_MASK 0x10 213 #define XGI_VB_OUTPUT_SCART 0x10 225 #define XGI_VB_CRT2 0x10 633 {0x00,0xE0,0x10,0x60}, 634 {0x00,0xEE,0x10,0x44}, 635 {0x00,0xF4,0x10,0x38}, 638 {0x00,0x00,0x10,0x20}, 639 {0x00,0x04,0x10, [all...] |
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/drivers/char/ |
H A D | scc.h | 152 #define CR_EXTSTAT_RESET 0x10 168 #define IDR_RX_INT_ALL 0x10 183 #define RCR_SEARCH_MODE 0x10 208 #define A1CR_SYNCR_BISYNC 0x10 226 #define TCR_SEND_BREAK 0x10 243 #define SOR_ALT_DTRREQ_TIMING 0x10 254 #define MIC_STATUS_HIGH 0x10 269 #define A2CR_GO_ACTIVE_ON_POLL 0x10 293 #define CCR_TXCLK_BRG 0x10 311 #define DCR_LOCAL_LOOPBACK 0x10 [all...] |
/netgear-R7000-V1.0.7.12_1.2.5/components/opensource/linux/linux-2.6.36/drivers/pcmcia/ |
H A D | cirrus.h | 67 #define PD67_MC1_SPKR_ENA 0x10 78 #define PD67_MC2_LED_ENA 0x10 /* IRQ 12 is LED enable */ 79 #define PD67_MC2_FAST_PCI 0x10 /* 6729: PCI bus > 25 MHz */ 110 #define PD67_EC1_INV_MGMT_IRQ 0x10 137 #define PD68_MC3_HW_SUSP 0x10
|