Lines Matching refs:dd_dev_err
1361 dd_dev_err(dd, "Invalid cntr register access mode");
1465 dd_dev_err(dd, "Could not acquire LCB for counter 0x%x", csr);
1515 dd_dev_err(dd, "Invalid cntr sw access mode");
1623 dd_dev_err(dd, "Per CPU cntrs can only be zeroed");
1625 dd_dev_err(dd, "Invalid cntr sw cpu access mode");
4045 dd_dev_err(dd, "Invalid cntr register access mode");
5901 dd_dev_err(dd, "Repeating %s bits 0x%llx - masking\n",
5925 dd_dev_err(dd, "Unexpected misc interrupt (%u) - reserved\n",
5959 dd_dev_err(dd,
5968 dd_dev_err(dd, "%s: context %u(%u): no sc?\n", __func__,
6013 dd_dev_err(sde->dd, "CONFIG SDMA(%u) %s:%d %s()\n", sde->this_idx,
6015 dd_dev_err(sde->dd, "CONFIG SDMA(%u) source: %u status 0x%llx\n",
6040 dd_dev_err(dd, "CONFIG SDMA(%u) %s:%d %s()\n", sde->this_idx,
6042 dd_dev_err(dd, "CONFIG SDMA(%u) source: %u\n", sde->this_idx,
6165 dd_dev_err(dd, "%s: command failed with error %d\n",
6179 dd_dev_err(dd, "%s: command failed with error %d\n",
6246 dd_dev_err(dd,
6284 dd_dev_err(dd, "%s: LCB access count is zero. Skipping.\n",
6293 dd_dev_err(dd,
6387 dd_dev_err(dd, "8051 request: unknown request 0x%x\n", type);
6550 dd_dev_err(dd, "%s: timeout starting 8051 firmware\n",
6699 dd_dev_err(
6706 dd_dev_err(dd,
6768 dd_dev_err(dd,
6802 dd_dev_err(dd,
6999 dd_dev_err(dd,
7344 dd_dev_err(dd,
7534 dd_dev_err(dd, "%s: unexpected remote tx rate %d, using 25Gb\n",
7621 dd_dev_err(ppd->dd,
7639 dd_dev_err(ppd->dd, "Link downgrade is really a link down, ignoring\n");
7649 dd_dev_err(ppd->dd,
7651 dd_dev_err(ppd->dd,
7662 dd_dev_err(ppd->dd,
7664 dd_dev_err(ppd->dd,
7776 dd_dev_err(dd, "8051 info error: %s\n",
7844 dd_dev_err(dd, "Lost 8051 heartbeat\n");
7853 dd_dev_err(dd, "8051 error: %s\n",
8114 dd_dev_err(dd, "Parity error in DC LBM block\n");
8116 dd_dev_err(dd, "Invalid DC interrupt %u\n", source);
8145 dd_dev_err(dd, "CONFIG SDMA(%u) %s:%d %s()\n", which,
8154 dd_dev_err(dd, "Invalid SDMA interrupt 0x%x\n", source);
8186 dd_dev_err(dd, "unexpected %s receive available context interrupt %u\n",
8217 dd_dev_err(dd, "unexpected %s receive urgent context interrupt %u\n",
8228 dd_dev_err(dd, "unexpected %s interrupt\n",
8276 dd_dev_err(dd, "invalid interrupt source %u\n", source);
8328 dd_dev_err(dd, "CONFIG SDMA(%u) %s:%d %s()\n", sde->this_idx,
8741 dd_dev_err(dd,
8800 dd_dev_err(dd, "8051 host command %u timeout\n", type);
8849 dd_dev_err(dd,
8887 dd_dev_err(dd, "%s: direct read failed, lane %d, field %d!\n",
9130 dd_dev_err(dd, "read idle message: type %d, err %d\n",
9164 dd_dev_err(dd, "send idle message: data 0x%llx, err %d\n",
9231 dd_dev_err(dd,
9234 dd_dev_err(dd, "Continuing with quick linkup\n");
9247 dd_dev_err(dd,
9299 dd_dev_err(dd,
9310 dd_dev_err(dd, "Invalid loopback mode %d\n", loopback);
9383 dd_dev_err(dd,
9431 dd_dev_err(dd,
9567 dd_dev_err(dd, "%s: QSFP cable temperature too high\n",
9572 dd_dev_err(dd, "%s: QSFP cable temperature too low\n",
9583 dd_dev_err(dd, "%s: QSFP supply voltage too high\n",
9588 dd_dev_err(dd, "%s: QSFP supply voltage too low\n",
9595 dd_dev_err(dd, "%s: Cable RX channel 1/2 power too high\n",
9600 dd_dev_err(dd, "%s: Cable RX channel 1/2 power too low\n",
9605 dd_dev_err(dd, "%s: Cable RX channel 3/4 power too high\n",
9610 dd_dev_err(dd, "%s: Cable RX channel 3/4 power too low\n",
9615 dd_dev_err(dd, "%s: Cable TX channel 1/2 bias too high\n",
9620 dd_dev_err(dd, "%s: Cable TX channel 1/2 bias too low\n",
9625 dd_dev_err(dd, "%s: Cable TX channel 3/4 bias too high\n",
9630 dd_dev_err(dd, "%s: Cable TX channel 3/4 bias too low\n",
9635 dd_dev_err(dd, "%s: Cable TX channel 1/2 power too high\n",
9640 dd_dev_err(dd, "%s: Cable TX channel 1/2 power too low\n",
9645 dd_dev_err(dd, "%s: Cable TX channel 3/4 power too high\n",
9650 dd_dev_err(dd, "%s: Cable TX channel 3/4 power too low\n",
9815 dd_dev_err(ppd->dd, "QSFP not responding, giving up\n");
9945 dd_dev_err(dd,
10303 dd_dev_err(dd, "Last %s LNI state complete frame 0x%08x:\n",
10305 dd_dev_err(dd, " last reported state state: %s (0x%x)\n",
10307 dd_dev_err(dd, " state successfully completed: %s\n",
10309 dd_dev_err(dd, " fail reason 0x%x: %s\n",
10311 dd_dev_err(dd, " passing lane mask: 0x%x", lanes);
10352 dd_dev_err(dd,
10420 dd_dev_err(dd,
10446 dd_dev_err(dd,
10487 dd_dev_err(dd,
10594 dd_dev_err(ppd->dd, "invalid host_link_state 0x%x\n",
10618 dd_dev_err(ppd->dd, "invalid host_link_state 0x%x\n",
10729 dd_dev_err(dd,
10737 dd_dev_err(dd,
10769 dd_dev_err(dd,
10779 dd_dev_err(dd,
10801 dd_dev_err(dd,
10854 dd_dev_err(dd,
10896 dd_dev_err(dd,
10904 dd_dev_err(dd,
10934 dd_dev_err(dd,
10955 dd_dev_err(dd, "%s: unexpected state transition from %s to %s\n",
11141 dd_dev_err(
11374 dd_dev_err(dd,
11381 dd_dev_err(dd,
11947 dd_dev_err(dd, "Receive header queue count too small\n");
11952 dd_dev_err(dd,
11959 dd_dev_err(dd, "Receive header queue count %d must be divisible by %lu\n",
12347 dd_dev_err(dd, "Counter %s not enabled", entry->name);
12398 dd_dev_err(dd, "Counter %s not enabled", entry->name);
12855 dd_dev_err(dd,
12879 dd_dev_err(dd, "Unexpected chip physical state of 0x%x\n",
12986 dd_dev_err(ppd->dd,
13017 dd_dev_err(ppd->dd,
13044 dd_dev_err(ppd->dd,
13077 dd_dev_err(ppd->dd,
13110 dd_dev_err(ppd->dd,
13277 dd_dev_err(dd, "remap interrupt err\n");
13394 dd_dev_err(dd,
13414 dd_dev_err(dd,
13449 dd_dev_err(dd, "RMT overflow: reduce the requested number of contexts\n");
13452 dd_dev_err(dd, "RMT overflow: reducing # user contexts from %u to %u\n",
13621 dd_dev_err(dd,
13847 dd_dev_err(dd,
13877 dd_dev_err(dd,
14077 dd_dev_err(dd, "%s: Could not restore PCI variables\n",
14087 dd_dev_err(dd, "%s: Could not restore PCI variables\n",
14457 dd_dev_err(dd, "FECN handling disabled - too many contexts allocated\n");
14533 dd_dev_err(dd, "Not enough RMT entries used = %d\n",
14572 dd_dev_err(dd, "Failed to update RMT for RSM%d rule\n", rule);
14989 dd_dev_err(dd, "Interrupt registers not properly mapped by VMM\n");
15035 dd_dev_err(dd, "Invalid num_vls %u, using %u VLs\n",
15123 dd_dev_err(dd, "num_vls %u too large, using %u VLs\n",
15385 dd_dev_err((dd), \