dev/iwn/if_iwn.c

545 	/* Allocate TX rings (16 on 4965AGN, 20 on >=5000). */
742  * Define specific configuration based on device id and subdevice id
1624  * NB: This kind of ROM can be found on 1000 or 6000 Series only.
1795 	/* TX scheduler rings must be aligned on a 1KB boundary. */
1809 	/* "Keep Warm" page must be aligned on a 4KB boundary. */
1822 	/* ICT table must be aligned on a 4KB boundary. */
1836 	/* Must be aligned on a 16-byte boundary. */
2204 	/* Adapter has to be powered on for EEPROM access to work. */
2777 	/* Default - transmit on the other antennas */
2813 	 * and set the relevant flags based on the node config.
3017 	/* Save RX statistics, they will be used on MPDU_RX_DONE. */
3333  * firmware on response to a CMD_CALIB_CONFIG command (5000 only).
3711 	 * happen on first authenticate after scanning.  To workaround
4220 	/* Force a complete recalibration on next init. */
4689 		 * negotiated AMPDU TX on.
5592 iwn_set_led(struct iwn_softc *sc, uint8_t which, uint8_t off, uint8_t on)
5608 	led.unit = htole32(10000);	/* on/off in unit of 100ms */
5610 	led.on = on;
5791 			/* Adjust TX power based on rate. */
6191  * Tune RF RX sensitivity based on the number of false alarms detected
7185 	 * a sysassert on a "good CRC threshold" of zero (== disabled),
7186 	 * on a radar channel even though this means that we should NOT
7190 	 * need to receive during our dwell time on a channel before
7438 	/* Link LED always on while associated. */
7485  * This function is called by upper layer on teardown of an HT-immediate
7797  * obtained on first boot from the initialization firmware.
8251 	/* Load the initialization firmware on first boot only. */