mips: octeon: Add Octeon III NIC23 board support

This patch adds the basic support for the PCIe target board equipped
with the Octeon III CN2350 SoC.

Signed-off-by: Stefan Roese <sr@denx.de>

mips: octeon: Kconfig: Enable CONFIG_SYS_PCI_64BIT

Setting CONFIG_SYS_PCI_64BIT is needed for correct PCIe functionality on
MIPS Octeon.

Signed-off-by: Stefan Roese <sr@denx.de>

mips: octeon: Add minimal Octeon 3 EBB7304 EVK support

This patch adds very basic minimal support for the Marvell Octeon 3
CN73xx based EBB7304 EVK. Please note that the basic Octeon port does
not support DDR3/4 initialization yet. To still use U-Boot on with this
port, the L2 cache (4MiB) is used as RAM. This way, U-Boot can boot
to the prompt on this board.

Supported devices:
- UART
- reset
- CFI parallel NOR flash

Signed-off-by: Stefan Roese <sr@denx.de>

mips: octeon: Initial minimal support for the Marvell Octeon SoC

This patch adds very basic support for the Octeon III SoCs. Only
CFI parallel NOR flash and UART is supported for now.

Please note that the basic Octeon port does not include the DDR3/4
initialization yet. This will be added in some follow-up patches
later. To still use U-Boot on with this port, the L2 cache (4MiB on
Octeon III CN73xx) is used as RAM. This way, U-Boot can boot to the
prompt on such boards.

Signed-off-by: Aaron Williams <awilliams@marvell.com>
Signed-off-by: Stefan Roese <sr@denx.de>

mips: octeon: Add minimal Octeon 3 EBB7304 EVK support

This patch adds very basic minimal support for the Marvell Octeon 3
CN73xx based EBB7304 EVK. Please note that the basic Octeon port does
not support DDR3/4 initialization yet. To still use U-Boot on with this
port, the L2 cache (4MiB) is used as RAM. This way, U-Boot can boot
to the prompt on this board.

Supported devices:
- UART
- reset
- CFI parallel NOR flash

Signed-off-by: Stefan Roese <sr@denx.de>

mips: octeon: Initial minimal support for the Marvell Octeon SoC

This patch adds very basic support for the Octeon III SoCs. Only
CFI parallel NOR flash and UART is supported for now.

Please note that the basic Octeon port does not include the DDR3/4
initialization yet. This will be added in some follow-up patches
later. To still use U-Boot on with this port, the L2 cache (4MiB on
Octeon III CN73xx) is used as RAM. This way, U-Boot can boot to the
prompt on such boards.

Signed-off-by: Aaron Williams <awilliams@marvell.com>
Signed-off-by: Stefan Roese <sr@denx.de>