selftests/powerpc: Don't rely on segfault to rerun the test

The test case tm-signal-context-force-tm expects a segfault to happen
on returning from signal handler, and then does a setcontext() to run
the test again. However, the test doesn't always segfault, causing the
test to run a single time.

This patch fixes the test by putting it within a loop and jumping, via
setcontext, just prior to the loop in case it segfaults. This way we
get the desired behavior (run the test COUNT_MAX times) regardless if
it segfaults or not. This also reduces the use of setcontext for
control flow logic, keeping it only in the segfault handler.

Also, since 'count' is changed within the signal handler, it is
declared as volatile to prevent any compiler optimization getting
confused with asynchronous changes.

Signed-off-by: Gustavo Luiz Duarte <gustavold@linux.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Link: https://lore.kernel.org/r/20200211033831.11165-3-gustavold@linux.ibm.com

selftests/powerpc: New TM signal self test

A new self test that forces MSR[TS] to be set without calling any TM
instruction. This test also tries to cause a page fault at a signal
handler, exactly between MSR[TS] set and tm_recheckpoint(), forcing
thread->texasr to be rewritten with TEXASR[FS] = 0, which will cause a BUG
when tm_recheckpoint() is called.

This test is not deterministic, since it is hard to guarantee that the page
access will cause a page fault. In order to force more page faults at
signal context, the signal handler and the ucontext are being mapped into a
MADV_DONTNEED memory chunks.

Tests have shown that the bug could be exposed with few interactions in a
buggy kernel. This test is configured to loop 5000x, having a good chance
to hit the kernel issue in just one run. This self test takes less than
two seconds to run.

This test uses set/getcontext because the kernel will recheckpoint
zeroed structures, causing the test to segfault, which is undesired because
the test needs to rerun, so, there is a signal handler for SIGSEGV which
will restart the test.

v2: Uses the MADV_DONTNEED memory advice
v3: Fix memcpy and 32-bits compilation
v4: Does not define unused macros

Signed-off-by: Breno Leitao <leitao@debian.org>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>