#
07c8a2dd |
|
22-Apr-2022 |
Vladimir Oltean <vladimir.oltean@nxp.com> |
selftests: drivers: dsa: add a subset of forwarding selftests This adds an initial subset of forwarding selftests which I considered to be relevant for DSA drivers, along with a forwarding.config that makes it easier to run them (disables veth pair creation, makes sure MAC addresses are unique and stable). The intention is to request driver writers to run these selftests during review and make sure that the tests pass, or at least that the problems are known. Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com> Signed-off-by: David S. Miller <davem@davemloft.net>
|
#
90b9566a |
|
22-Apr-2022 |
Vladimir Oltean <vladimir.oltean@nxp.com> |
selftests: forwarding: add a test for local_termination.sh This tests the capability of switch ports to filter out undesired traffic. Different drivers are expected to have different capabilities here (so some may fail and some may pass), yet the test still has some value, for example to check for regressions. There are 2 kinds of failures, one is when a packet which should have been accepted isn't (and that should be fixed), and the other "failure" (as reported by the test) is when a packet could have been filtered out (for being unnecessary) yet it was received. The bridge driver fares particularly badly at this test: TEST: br0: Unicast IPv4 to primary MAC address [ OK ] TEST: br0: Unicast IPv4 to macvlan MAC address [ OK ] TEST: br0: Unicast IPv4 to unknown MAC address [FAIL] reception succeeded, but should have failed TEST: br0: Unicast IPv4 to unknown MAC address, promisc [ OK ] TEST: br0: Unicast IPv4 to unknown MAC address, allmulti [FAIL] reception succeeded, but should have failed TEST: br0: Multicast IPv4 to joined group [ OK ] TEST: br0: Multicast IPv4 to unknown group [FAIL] reception succeeded, but should have failed TEST: br0: Multicast IPv4 to unknown group, promisc [ OK ] TEST: br0: Multicast IPv4 to unknown group, allmulti [ OK ] TEST: br0: Multicast IPv6 to joined group [ OK ] TEST: br0: Multicast IPv6 to unknown group [FAIL] reception succeeded, but should have failed TEST: br0: Multicast IPv6 to unknown group, promisc [ OK ] TEST: br0: Multicast IPv6 to unknown group, allmulti [ OK ] mainly because it does not implement IFF_UNICAST_FLT. Yet I still think having the test (with the failures) is useful in case somebody wants to tackle that problem in the future, to make an easy before-and-after comparison. Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com> Signed-off-by: David S. Miller <davem@davemloft.net>
|