ASoC: rt5682s: Add LDO output selection for dacref

Add LDO output selection for dacref.

Signed-off-by: Jack Yu <jack.yu@realtek.com>
Link: https://lore.kernel.org/r/62cad4e51c044108bad872ab349e36f8@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Convert to use GPIO descriptors

Convert the RT5682S to use GPIO descriptors and drop the
legacy GPIO headers.

We remove the global GPIO number from the platform data,
but it is still possible to create board files using GPIO
descriptor tables, if desired.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20230817-descriptors-asoc-rt-v2-5-02fa2ca3e5b0@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>

SoC: rt5682s: Disable jack detection interrupt during suspend

The rt5682s driver switches its regmap to cache-only when the
device suspends and back to regular mode on resume. When the
jack detect interrupt fires rt5682s_irq() schedules the jack
detect work. This can result in invalid reads from the regmap
in cache-only mode if the work runs before the device has
resumed:

[ 19.672162] rt5682s 2-001a: ASoC: error at soc_component_read_no_lock on rt5682s.2-001a for register: [0x000000f0] -16

Disable the jack detection interrupt during suspend and
re-enable it on resume. The driver already schedules the
jack detection work on resume, so any state change during
suspend is still handled.

Signed-off-by: Matthias Kaehlcke <mka@chromium.org>
Link: https://lore.kernel.org/r/20230209012002.1.Ib4d6481f1d38a6e7b8c9e04913c02ca88c216cf6@changeid
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Support DBVDD and LDO1-IN supplies

Add support for the DBVDD and LDO1-IN supplies.

Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Signed-off-by: Nícolas F. R. A. Prado <nfraprado@collabora.com>
Link: https://lore.kernel.org/r/20221102182002.255282-6-nfraprado@collabora.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Fix the TDM Tx settings

Complete the missing and correct the TDM Tx settings.

Signed-off-by: Derek Fang <derek.fang@realtek.com>
Link: https://lore.kernel.org/r/20221012031320.6980-1-derek.fang@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Reduce coupling of Micbias and Vref2 settings

Some parts of rt5682s CCF function are implemented by
'MICBIAS' and 'Vref2' dapm widgets.

There is a risk of causing not expected behavior if we
mix using dapm and CCF operations in machine specific code.
This patch reduces the coupling.

Signed-off-by: Derek Fang <derek.fang@realtek.com>
Link: https://lore.kernel.org/r/20220913025658.5005-1-derek.fang@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Separate the regulator consumer controls

Control the regulators separately instead of using regulator_bulk to
accord to the timing request in the datasheet.

Signed-off-by: Derek Fang <derek.fang@realtek.com>
Link: https://lore.kernel.org/r/20220328053338.21441-1-derek.fang@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Fix the wrong jack type detected

Some powers were changed during the jack insert detection and clk's
enable/disable in CCF.
If in parallel, the influence has a chance to detect the wrong jack
type.

We refer to the below commit of the variant codec (rt5682) to fix
this issue.
ASoC: rt5682: Fix deadlock on resume

1. Remove rt5682s_headset_detect in rt5682s_jd_check_handler and
use jack_detect_work instead of.
2. Use dapm mutex used in CCF to protect most of jack_detect_work.

Signed-off-by: Derek Fang <derek.fang@realtek.com>
Link: https://lore.kernel.org/r/20220223101450.4577-1-derek.fang@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Fix hp pop produced immediately after resuming

When the system plays a sound immediately after resuming from S3,
it could hear a little pop from headphones.
It is due to the HP was unmuted before the completion of
jack re-detection finished in parallel.

This patch adds a lock to make sure the HP unmute after jack detect handler,
and adds a few depop changes.

Signed-off-by: Derek Fang <derek.fang@realtek.com>
Link: https://lore.kernel.org/r/20211007085519.12543-1-derek.fang@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Enable ASRC auto-disable to fix pop during jack plug-in while playback

When codec's ASRC was enabled, the DA and AD filters use
the reference clk which tracks the I2S clks.
And if the I2S clks' timing of open and close are not expected,
this patch allows the filters to switch to use sysclk if
ASRC's ref clks disappeared and could fix the below possible issues:
1. Avoid DA filter to keep surplus samples.
2. Avoid that AD filter works failed during dapm's power on.

For example,
if I2S clks were closed before dacdat during playback off
due to jack unplug, it causes ref clks disappeared and
DA filter remained some samples which will produce pop noise
on the next HP playback.
ASRC auto-disable could clear the samples during the playback off.

Signed-off-by: Derek Fang <derek.fang@realtek.com>
Link: https://lore.kernel.org/r/20211001074113.2223-1-derek.fang@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Revise the macro RT5682S_PLLB_SRC_MASK

Revise the macro RT5682S_PLLB_SRC_MASK to 0x1
because the mux is only two-source.

Signed-off-by: Derek Fang <derek.fang@realtek.com>
Link: https://lore.kernel.org/r/20210930102928.28628-3-derek.fang@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: rt5682s: Add driver for ALC5682I-VS codec

This is an initial codec driver for Realtek ALC5682I-VS codec.

Signed-off-by: Derek Fang <derek.fang@realtek.com>
Signed-off-by: Derek Fang <derek.fang@realtek.com<mailto:derek.fang@realtek.com>>
Link: https://lore.kernel.org/r/20210831130258.19286-1-derek.fang@realtek.com
Signed-off-by: Mark Brown <broonie@kernel.org>