ASoC: SOF: IPC4: synchronize fw_config_params with fw definitions

Update fw_config_params in driver.

Signed-off-by: Rander Wang <rander.wang@intel.com>
Reviewed-by: Péter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Signed-off-by: Bard Liao <yung-chuan.liao@linux.intel.com>
Link: https://msgid.link/r/20231215083102.3064200-2-yung-chuan.liao@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: ipc4: Add data struct for module notification message from firmware

With the module notification message the information about the notification
is provided via the mailbox with the sof_ipc4_notify_module_data struct.

It contains the module and instance id of the sender of the notification,
the event_id and optionally additional data which is module and event
specific.

At the same time add definitions to identify ALSA kcontrol change
notification.
These notifications use standardized event_id, modules must follow this if
they support such notifications:
upper 16 bit: 0xA15A as a magic identification value
lower 16 bit: param_id of the changed control

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Link: https://lore.kernel.org/r/20231124150853.18648-3-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: ipc4-mtrace: move debug slot related definitions to header.h

The macro definitions of debug slot can be used by gdb, telemetry
and mtrace log, so move these definitions to header.h from mtrace.
Then these macro definitions can be shared

Signed-off-by: Rander Wang <rander.wang@intel.com>
Reviewed-by: Péter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Kai Vehmanen <kai.vehmanen@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Guennadi Liakhovetski <guennadi.liakhovetski@linux.intel.com>
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Link: https://lore.kernel.org/r/20230919092416.4137-3-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: ipc4: Add new message type: SOF_IPC4_GLB_LOAD_LIBRARY_PREPARE

On Intel platforms there is a strict order requirement for the DMA
programming:
DSP side configures the buffer and sets the GEN bit
Host side sets the RUN bit.

In order to follow this flow, a new global message type has been added to
prepare the DSP side of the DMA:

host sends LOAD_LIBRARY_PREPARE with the dma_id
DSP side sets its buffer and sets the GEN bit
Host sets the RUN bit
Host sends LOAD_LIBRARY with dma_id and lib_id
DSP receives the library data.

It is up to the platform code to use the new prepare stage message and how
to handle the reply to it from the firmware, which can indicate that the
message type is not supported/handled.
In this case the kernel should proceed to the LOAD_LIBRARY stage assuming
a single stage library loading:

host sends LOAD_LIBRARY_PREPARE with the dma_id
DSP replies that the message type is not supported/handled
Host acknowledges the return code and sets the RUN bit
Host sends LOAD_LIBRARY with dma_id and lib_id
DSP receives the library data.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Guennadi Liakhovetski <guennadi.liakhovetski@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Reviewed-by: Chao Song <chao.song@linux.intel.com>
Link: https://lore.kernel.org/r/20230915114018.1701-4-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: ipc4: Add macros for chain-dma message bits

In the chained DMA mode, the firmware allocates buffers for the host
and link DMA, and takes care of copying data between host- and
link-DMA buffers in a low-latency thread. This is different to a
regular pipeline, no processing is allowed, and the connection between
host- and link DMA is handled with a dedicated IPC.

This patch exposes the macros needed to create the required IPC messages.

Signed-off-by: Jyri Sarha <jyri.sarha@intel.com>
Reviewed-by: Rander Wang <rander.wang@intel.com>
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Link: https://lore.kernel.org/r/20230321092654.7292-3-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: ipc4: Add macro to set the core_id in create_pipe message

The create pipeline message can carry the target code_id which is set to
0 at the moment.

Add macros to set the core_id in the message extension.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Link: https://lore.kernel.org/r/20230307123556.31328-2-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: ipc4-pcm: Use the PCM stream's pipeline_info during trigger

Use the list of pipelines in the PCM stream's pipeline info to trigger
the pipelines in the right order. Add a helper for triggering pipelines
in batch mode that will be used to trigger multiple pipelines at the
same time.

Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Reviewed-by: Libin Yang <libin.yang@intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Péter Ujfalusi <peter.ujfalusi@linux.intel.com>
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Link: https://lore.kernel.org/r/20230127120031.10709-12-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: Intel: Add ipc4 library loading implementation

On Intel HDA platforms the library loading is done via DMA and an IPC
message is also need to be sent to initiate the downloading of the new
library.

Co-developed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Chao Song <chao.song@intel.com>
Reviewed-by: Kai Vehmanen <kai.vehmanen@linux.intel.com>
Link: https://lore.kernel.org/r/20221020121238.18339-16-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: ipc4: Add macro to get core ID from log buffer status message

The LOG_BUFFER_STATUS message includes the ID of the core which updated
its log buffer.
With IPC4 each core logs to a different slot in the debug window.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Rander Wang <rander.wang@intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Link: https://lore.kernel.org/r/20220909114332.31393-3-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: ipc4: Add set_core_state pm_ops implementation

IPC4 uses the SET_DX message to enable/disable cores managed by the DSP.
The dx_state.core_mask indicates which core is going to change state,
the dx_state.dx_mask is to power on (1) or off (0) the core.
In the dx_mask only those bits (cores) checked which bit is set in the
core_mask, other bits (cores) ignored.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Reviewed-by: Bard Liao <yung-chuan.liao@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Link: https://lore.kernel.org/r/20220610083549.16773-5-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: SOF: Add initial header file for ipc4

The header file contains essential structure definitions, description of
bit fields and bits in the ipc4 header and an internally used ipc4 message
container definition.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Bard Liao <yung-chuan.liao@linux.intel.com>
Reviewed-by: Rander Wang <rander.wang@intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Link: https://lore.kernel.org/r/20220505094818.10346-3-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>