drivers/gpio/nomadik: move dummy nmk_gpio_dbg_show_one() to header

When `CONFIG_DEBUG_FS` is disabled, nmk_gpio_dbg_show_one() is an
empty dummy function; this however triggers a `-Wmissing-prototypes`
warning and later a linker error because the function is also used by
drivers/pinctrl/nomadik/pinctrl-nomadik.c, therefore it needs to be
non-static.

To allow both sources to access this dummy function, this patch moves
it to the header, adding the `#ifdef CONFIG_DEBUG_FS` there as well.

Signed-off-by: Max Kellermann <max.kellermann@ionos.com>
Link: https://lore.kernel.org/r/20240311133223.3429428-1-max.kellermann@ionos.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

gpio: nomadik: Finish conversion to use firmware node APIs

Previously driver got a few updates in order to replace OF APIs by
respective firmware node, however it was not finished to the logical
end, e.g., some APIs that has been used are still require OF node
to be passed. Finish that job by converting leftovers to use firmware
node APIs.

Signed-off-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Link: https://lore.kernel.org/r/20240302173401.217830-1-andy.shevchenko@gmail.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

gpio: nomadik: support mobileye,eyeq5-gpio

We create a custom compatible for the STA2X11 IP block as integrated
into the Mobileye EyeQ5 platform. Its wake and alternate functions have
been disabled, we want to avoid touching those registers.

We both do: (1) early return in functions that do not support the
platform, but with warnings, and (2) avoid calling those functions in
the first place.

We ensure that pinctrl-nomadik is not used with this STA2X11 variant.

Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
Link: https://lore.kernel.org/r/20240228-mbly-gpio-v2-24-3ba757474006@bootlin.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

gpio: nomadik: extract GPIO platform driver from drivers/pinctrl/nomadik/

Previously, drivers/pinctrl/nomadik/pinctrl-nomadik.c registered two
platform drivers: pinctrl & GPIO. Move the GPIO aspect to the
drivers/gpio/ folder, as would be expected.

Both drivers are intertwined for a reason; pinctrl requires access to
GPIO registers for pinmuxing, pull-disable, disabling interrupts while
setting the muxing and wakeup control. Information sharing is done
through a shared array containing GPIO chips and a few helper
functions. That shared array is not touched from gpio-nomadik when
CONFIG_PINCTRL_NOMADIK is not defined.

Make no change to the code that moved into gpio-nomadik; there should be
no behavior change following. A few functions are shared and header
comments are added. Checkpatch warnings are addressed. NUM_BANKS is
renamed to NMK_MAX_BANKS.

It is supported to compile gpio-nomadik without pinctrl-nomadik. The
opposite is not true.

Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
Link: https://lore.kernel.org/r/20240228-mbly-gpio-v2-6-3ba757474006@bootlin.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>