slimbus: stream: add stream support

This patch adds support to SLIMbus stream apis for slimbus device.
SLIMbus streaming involves adding support to Data Channel Management and
channel Reconfiguration Messages to slim core plus few stream apis.
>From slim device side the apis are very simple mostly inline with other
stream apis.

Currently it only supports Isochronous and Push/Pull transport protocols,
which are sufficient for audio use cases.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

slimbus: ngd: Add qcom SLIMBus NGD driver

This patch adds suppor to Qualcomm SLIMBus Non-Generic Device (NGD)
controller driver.
This is light-weight SLIMBus controller driver responsible for
communicating with slave HW directly over the bus using messaging
interface, and communicating with master component residing on ADSP
for bandwidth and data-channel management

Based on intial work from
Karthikeyan Ramasubramanian <kramasub@codeaurora.org> and
Sagar Dharia <sdharia@codeaurora.org>

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Tested-by: Craig Tatlor <ctatlor97@gmail.com>
Reviewed-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

slimbus: qcom: Add Qualcomm Slimbus controller driver

This controller driver programs manager, interface, and framer
devices for Qualcomm's slimbus HW block.
Manager component currently implements logical address setting,
and messaging interface.
Interface device reports bus synchronization information, and framer
device clocks the bus from the time it's woken up, until clock-pause
is executed by the manager device.

Signed-off-by: Sagar Dharia <sdharia@codeaurora.org>
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviwed-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

slimbus: Add support for 'clock-pause' feature

Per SLIMbus specification, a reconfiguration sequence known as
'clock pause' needs to be broadcast over the bus while entering low-
power mode. Clock-pause is initiated by the controller driver.
To exit clock-pause, controller typically wakes up the framer device.
Since wakeup precedure is controller-specific, framework calls it via
controller's function pointer to invoke it.

Signed-off-by: Sagar Dharia <sdharia@codeaurora.org>
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviwed-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

slimbus: Add messaging APIs to slimbus framework

SLIMbus devices use value-element, and information elements to
control device parameters (e.g. value element is used to represent
gain for codec, information element is used to represent interrupt
status for codec when codec interrupt fires).
Messaging APIs are used to set/get these value and information
elements. SLIMbus specification uses 8-bit "transaction IDs" for
messages where a read-value is anticipated. Framework uses a table
of pointers to store those TIDs and responds back to the caller in
O(1).
Caller can do synchronous and asynchronous reads/writes.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviwed-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

slimbus: Add SLIMbus bus type

SLIMbus (Serial Low Power Interchip Media Bus) is a specification
developed by MIPI (Mobile Industry Processor Interface) alliance.
SLIMbus is a 2-wire implementation, which is used to communicate with
peripheral components like audio-codec.
SLIMbus uses Time-Division-Multiplexing to accommodate multiple data
channels, and control channel. Control channel has messages to do
device-enumeration, messages to send/receive control-data to/from
SLIMbus devices, messages for port/channel management, and messages to
do bandwidth allocation.
The framework supports multiple instances of the bus (1 controller per
bus), and multiple slave devices per controller.

This patch adds support to basic silmbus core which includes support to
SLIMbus type, slimbus device registeration and some basic data structures.

Signed-off-by: Sagar Dharia <sdharia@codeaurora.org>
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviwed-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>