wifi: rtw89: 8922a: add helper of set_channel

Reset hardware state to prevent hardware stays at abnormal state during
setting channel. Besides, add preparation for MLO/DBCC before setting
channel, and reconfigure registers after that.

Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://msgid.link/20240215055741.14148-5-pkshih@realtek.com

wifi: rtw89: 8922a: add set_channel RF part

Configure RF registers according to band, channel, bandwidth. Since this
chip will support MLO, it needs check the operating mode to decide paths
we are going to configure.

Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://msgid.link/20240215055741.14148-4-pkshih@realtek.com

wifi: rtw89: 8922a: add chip_ops::rfk_hw_init

Add a chip_ops for WiFi 7 chips to set additional RF configurations
including MLO and PLL settings.

Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://msgid.link/20240202030642.108385-12-pkshih@realtek.com

wifi: rtw89: 8922a: add chip_ops::cfg_txrx_path

This function is to set TX/RX path. Especially for 1SS rate, it can select
to TX on one or two antenna. Before this operation, stop hardware to
prevent transmitting/receiving unexpected packets. After that, restore
settings and reset hardware to prevent it stays on abnormal state.

Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://msgid.link/20240124033637.12330-4-pkshih@realtek.com