net: ti: icss-iep: fix setting counter value

Currently icss_iep_set_counter() writes the upper 32-bits of the
counter value to both the lower and upper counter registers, so
fix this by writing the appropriate value to the lower register.

Fixes: c1e0230eeaab ("net: ti: icss-iep: Add IEP driver")
Signed-off-by: Diogo Ivo <diogo.ivo@siemens.com>
Link: https://lore.kernel.org/r/20231107120037.1513546-1-diogo.ivo@siemens.com
Signed-off-by: Paolo Abeni <pabeni@redhat.com>

net: ti: icssg-prueth: am65x SR2.0 add 10M full duplex support

For AM65x SR2.0 it's required to enable IEP1 in raw 64bit mode which is
used by PRU FW to monitor the link and apply w/a for 10M link issue.
Note. No public errata available yet.

Without this w/a the PRU FW will stuck if link state changes under TX
traffic pressure.

Hence, add support for 10M full duplex for AM65x SR2.0:
- add new IEP API to enable IEP, but without PTP support
- add pdata quirk_10m_link_issue to enable 10M link issue w/a.

Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Reviewed-by: Roger Quadros <rogerq@kernel.org>
Reviewed-by: Simon Horman <horms@kernel.org>
Reviewed-by: Jacob Keller <jacob.e.keller@intel.com>
Signed-off-by: MD Danish Anwar <danishanwar@ti.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

net: ti: icss-iep: Add IEP driver

Add a driver for Industrial Ethernet Peripheral (IEP) block of PRUSS to
support timestamping of ethernet packets and thus support PTP and PPS
for PRU ethernet ports.

Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
Signed-off-by: Murali Karicheri <m-karicheri2@ti.com>
Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Reviewed-by: Simon Horman <horms@kernel.org>
Signed-off-by: MD Danish Anwar <danishanwar@ti.com>
Signed-off-by: David S. Miller <davem@davemloft.net>