octeontx2-pf: Use PTP HW timestamp counter atomic update feature

Some of the newer silicon versions in CN10K series supports a feature
where in the current PTP timestamp in HW can be updated atomically
without losing any cpu cycles unlike read/modify/write register.
This patch uses this feature so that PTP accuracy can be improved
while adjusting the master offset in HW. There is no need for SW
timecounter when using this feature. So removed references to SW
timecounter wherever appropriate.

Signed-off-by: Sai Krishna <saikrishnag@marvell.com>
Signed-off-by: Naveen Mamindlapalli <naveenm@marvell.com>
Signed-off-by: Sunil Kovvuri Goutham <sgoutham@marvell.com>
Reviewed-by: Kalesh AP <kalesh-anakkur.purayil@broadcom.com>
Reviewed-by: Simon Horman <horms@kernel.org>
Reviewed-by: Leon Romanovsky <leonro@nvidia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

octeontx2-af: Add PTP PPS Errata workaround on CN10K silicon

Errata:
The ptp_clock_hi rollsover to zero one clock cycle before it
reaches one second boundary. As a result, the pps threshold
comparison fails after one second and the pps output signal
won't toggle further.

This patch workarounds the issue by programming the pps_lo_incr
register to 500msec minus one clock cycle period, ensuring that
the pps threshold comparison succeeds at one second rollover
boundary and pps edge toggles. After that point, the driver will
have enough time (~500msec) to reset the pps threshold value.
After each one second boundary, hrtimer is invoked which resets
the pps threshold value.

Signed-off-by: Naveen Mamindlapalli <naveenm@marvell.com>
Signed-off-by: Rakesh Babu Saladi <rsaladi2@marvell.com>
Signed-off-by: Sunil Kovvuri Goutham <sgoutham@marvell.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

octeontx2-pf: cn10k: add support for new ptp timestamp format

The cn10k hardware ptp timestamp format has been modified primarily
to support 1-step ptp clock. The 64-bit timestamp used by hardware is
split into two 32-bit fields, the upper one holds seconds, the lower
one nanoseconds. A new register (PTP_CLOCK_SEC) has been added that
returns the current seconds value. The nanoseconds register PTP_CLOCK_HI
resets after every second. The cn10k RPM block provides Rx/Tx timestamps
to the NIX block using the new timestamp format. The software can read
the current timestamp in nanoseconds by reading both PTP_CLOCK_SEC &
PTP_CLOCK_HI registers.

This patch provides support for new timestamp format.

Signed-off-by: Naveen Mamindlapalli <naveenm@marvell.com>
Signed-off-by: Sunil Kovvuri Goutham <sgoutham@marvell.com>
Signed-off-by: Rakesh Babu Saladi <rsaladi2@marvell.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

octeontx2-af: Add external ptp input clock

PTP hardware block can be configured to utilize
the external clock. Also the current ptp timestamp
can be captured when external trigger is applied on
a gpio pin. These features are required in scenarios
like connecting a external timing device to the chip
for time synchronization. The timing device provides
the clock and trigger(PPS signal) to the PTP block.
This patch does the following:
1. configures PTP block to use external clock
frequency and timestamp capture on external event.
2. sends PTP_REQ_EXTTS events to kernel ptp phc susbsytem
with captured timestamps
3. aligns PPS edge to adjusted ptp clock in the ptp device
by setting the PPS_THRESH to the reminder of the last
timestamp value captured by external PPS

Signed-off-by: Yi Guo <yig@marvell.com>
Signed-off-by: Hariprasad Kelam <hkelam@marvell.com>
Signed-off-by: Subbaraya Sundeep <sbhatta@marvell.com>
Signed-off-by: Sunil Goutham <sgoutham@marvell.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

octeontx2-af: Use ptp input clock info from firmware data

The input clock frequency of PTP block is figured
out from hardware reset block currently. The firmware
data already has this info in sclk. Hence simplify
ptp driver to use sclk from firmware data.

Signed-off-by: Subbaraya Sundeep <sbhatta@marvell.com>
Signed-off-by: Hariprasad Kelam <hkelam@marvell.com>
Signed-off-by: Sunil Goutham <sgoutham@marvell.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

octeontx2-af: Fix inconsistent license text

Fixed inconsistent license text across the RVU admin
function driver.

Signed-off-by: Sunil Goutham <sgoutham@marvell.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

octeontx2-af: Add support for Marvell PTP coprocessor

Precision Timestamping block found on Octeontx2
platform is an independent coprocessor and has
internal PTP hardware clock. Once configured PTP
runs independently and when a packet arrives
CGX hardware block gets the current timestamp
from PTP block and forwards the packet to NIX
by prepending timestamp to the packet.
This patch adds the pci driver for PTP block.
The driver gets registered by AF driver and does
initial configuration and exposes a mailbox function to
read and adjust PTP hardware clock. The mailbox function
is called by AF consumers like netdev drivers or
userspace drivers. Since PTP being a single block
in platform this driver helps in accessing PTP
block by any AF consumer.

Co-developed-by: Subbaraya Sundeep <sbhatta@marvell.com>
Signed-off-by: Subbaraya Sundeep <sbhatta@marvell.com>
Signed-off-by: Aleksey Makarov <amakarov@marvell.com>
Signed-off-by: Sunil Goutham <sgoutham@marvell.com>
Acked-by: Richard Cochran <richardcochran@gmail.com>
Acked-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>