mmc: Add quirk MMC_QUIRK_BROKEN_CACHE_FLUSH for Micron eMMC Q2J54A

Micron MTFC4GACAJCN eMMC supports cache but requires that flush cache
operation be allowed only after a write has occurred. Otherwise, the
cache flush command or subsequent commands will time out.

Signed-off-by: Bean Huo <beanhuo@micron.com>
Signed-off-by: Rafael Beims <rafael.beims@toradex.com>
Cc: stable@vger.kernel.org
Link: https://lore.kernel.org/r/20231030224809.59245-1-beanhuo@iokpp.de
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: Add MMC_QUIRK_BROKEN_SD_CACHE for Kingston Canvas Go Plus from 11/2019

This microSD card never clears Flush Cache bit after cache flush has
been started in sd_flush_cache(). This leads e.g. to failure to mount
file system. Add a quirk which disables the SD cache for this specific
card from specific manufacturing date of 11/2019, since on newer dated
cards from 05/2023 the cache flush works correctly.

Fixes: 08ebf903af57 ("mmc: core: Fixup support for writeback-cache for eMMC and SD")
Signed-off-by: Marek Vasut <marex@denx.de>
Link: https://lore.kernel.org/r/20230620102713.7701-1-marex@denx.de
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: Add SD card quirk for broken discard

Some SD-cards from Sandisk that are SDA-6.0 compliant reports they supports
discard, while they actually don't. This might cause mk2fs to fail while
trying to format the card and revert it to a read-only mode.

To fix this problem, let's add a card quirk (MMC_QUIRK_BROKEN_SD_DISCARD)
to indicate that we shall fall-back to use the legacy erase command
instead.

Signed-off-by: Avri Altman <avri.altman@wdc.com>
Cc: stable@vger.kernel.org
Link: https://lore.kernel.org/r/20220928095744.16455-1-avri.altman@wdc.com
[Ulf: Updated the commit message]
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: transplant ti,wl1251 quirks from to be retired omap_hsmmc

The TiWi WL1251 WiFi chip needs special setup of the sdio
interface before it can be probed.

So far, this is done in omap_hsmmc_init_card() in omap_hsmmc.c
which makes it useable only if connected to omap devices
which use the omap_hsmmc. The OpenPandora is the most promient
example.

There are plans to switch to a newer sdhci-omap driver and
retire omap_hsmmc. Hence this quirk must be reworked or moved
somewhere else. Ideally to some location that is not dependent
on the specific SoC mmc host driver.

This is achieved by the new mmc_fixup_device() option introduced
by ("mmc: allow to match the device tree to apply quirks") to match
through device tree compatible string.

This quirk will be called early right after where host->ops->init_card()
and thus omap_hsmmc_init_card() was previously called.

Note that we do not need to transplant

card->ocr = 0x80;

because we rely on ("mmc: core: Fixup storing of OCR for MMC_QUIRK_NONSTD_SDIO").

Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/774565df7f02124c003aaf8b879706352548f832.1636564631.git.hns@goldelico.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: provide macro and table to match the device tree to apply quirks

This (initially empty) table allows to match quirks early based
on .compatible of the child node of some mmc/sdio interface.

This allows to add quirks based on device tree instead of having
card specific code in the host ops.

A new macro SDIO_FIXUP_COMPATIBLE makes the definition readable.

And we call mmc_fixup_device(sdio_card_init_methods) just after
where host->ops->init_card() can be optionally called.

Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>
Link: https://lore.kernel.org/r/b13fd8b3eebc3c23b6816b254a518c224cbdcfd4.1636564631.git.hns@goldelico.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: allow to match the device tree to apply quirks

MMC subsystem provides a way to apply quirks when a device match some
properties (VID, PID, etc...) Unfortunately, some SDIO devices do not
comply with the SDIO specification and does not provide reliable VID/PID
(eg. Silabs WF200).

So, the drivers for these devices rely on device tree to identify the
device.

This patch allows the MMC to also rely on the device tree to apply a
quirk.

Signed-off-by: Jérôme Pouiller <jerome.pouiller@silabs.com>
Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/9e68e3d23e62a78527aabc1281f89e15200c7d09.1636564631.git.hns@goldelico.com
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 194

Based on 1 normalized pattern(s):

license terms gnu general public license gpl version 2

extracted by the scancode license scanner the SPDX license identifier

GPL-2.0-only

has been chosen to replace the boilerplate/reference in 161 file(s).

Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Reviewed-by: Allison Randal <allison@lohutok.net>
Reviewed-by: Alexios Zavras <alexios.zavras@intel.com>
Reviewed-by: Steve Winslow <swinslow@gmail.com>
Reviewed-by: Richard Fontana <rfontana@redhat.com>
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190528170027.447718015@linutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

mmc: core: Cleanup BKOPS support

It's been ~6 years ago since we introduced the BKOPS support for eMMC
cards. The current code is a bit messy and primarily that's because it
prepares to support running BKOPS in an asynchronous mode. However, that
mode has never been fully implemented/enabled. Instead BKOPS is always
executed in synchronously, when the card has reported an urgent BKOPS
level.

For these reasons, let's make the code more readable by dropping the unused
parts. Let's also rename mmc_start_bkops() to mmc_run_bkops(), as to make
it more descriptive.

Cc: Jaehoon Chung <jh80.chung@samsung.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: Add a new quirk for limiting clock rate

This patch adds a quirk to limit clock rate which
can be used to reduce the SDIO clock rate for some
chips with broken UHS.

Signed-off-by: Harish Jenny K N <harish_kandiga@mentor.com>
Reviewed-by: Shawn Lin <shawn.lin@rock-chips.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: Disable HPI for certain Micron (Numonyx) eMMC cards

Certain Micron eMMC v4.5 cards might get broken when HPI feature is used
and hence this patch disables the HPI feature for such buggy cards.

In U-Boot, these cards are reported as

Manufacturer: Micron (ID: 0xFE)
OEM: 0x4E
Name: MMC32G
Revision: 19 (0x13)
Serial: 959241022 Manufact. date: 8/2015 (0x82) CRC: 0x00
Tran Speed: 52000000
Rd Block Len: 512
MMC version 4.5
High Capacity: Yes
Capacity: 29.1 GiB
Boot Partition Size: 16 MiB
Bus Width: 8-bit

According to JEDEC JEP106 manufacturer 0xFE is Numonyx, which was bought by
Micron.

Signed-off-by: Dirk Behme <dirk.behme@de.bosch.com>
Signed-off-by: Mark Craske <Mark_Craske@mentor.com>
Cc: <stable@vger.kernel.org> # 4.8+
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: Disable HPI for certain Micron (Numonyx) eMMC cards

Certain Micron eMMC v4.5 cards might get broken when HPI feature is used
and hence this patch disables the HPI feature for such buggy cards.

In U-Boot, these cards are reported as

Manufacturer: Micron (ID: 0xFE)
OEM: 0x4E
Name: MMC32G
Revision: 19 (0x13)
Serial: 959241022 Manufact. date: 8/2015 (0x82) CRC: 0x00
Tran Speed: 52000000
Rd Block Len: 512
MMC version 4.5
High Capacity: Yes
Capacity: 29.1 GiB
Boot Partition Size: 16 MiB
Bus Width: 8-bit

According to JEDEC JEP106 manufacturer 0xFE is Numonyx, which was bought by
Micron.

Signed-off-by: Dirk Behme <dirk.behme@de.bosch.com>
Signed-off-by: Mark Craske <Mark_Craske@mentor.com>
Cc: <stable@vger.kernel.org> # 4.8+
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: apply NO_CMD23 quirk to some specific cards

To get an usdhc Apacer and some ATP SD cards work reliable, CMD23 needs
to be disabled. This has been tested on i.MX6 (sdhci-esdhc) and rk3288
(dw_mmc-rockchip).

Without this patch on i.MX6 (sdhci-esdhc):

$ dd if=/dev/urandom of=/mnt/test bs=1M count=10 conv=fsync

| <mmc0: starting CMD23 arg 00000400 flags 00000015>
| mmc0: starting CMD25 arg 00a71f00 flags 000000b5
| mmc0: blksz 512 blocks 1024 flags 00000100 tsac 3000 ms nsac 0
| mmc0: CMD12 arg 00000000 flags 0000049d
| sdhci [sdhci_irq()]: *** mmc0 got interrupt: 0x00000001
| mmc0: Timeout waiting for hardware interrupt.

Without this patch on rk3288 (dw_mmc-rockchip):

| mmc1: Card stuck in programming state! mmcblk1 card_busy_detect
| dwmmc_rockchip ff0c0000.dwmmc: Busy; trying anyway
| mmc_host mmc1: Bus speed (slot 0) = 400000Hz (slot req 400000Hz,
| actual 400000HZ div = 0)
| mmc1: card never left busy state
| mmc1: tried to reset card, got error -110
| blk_update_request: I/O error, dev mmcblk1, sector 139778
| Buffer I/O error on dev mmcblk1p1, logical block 131586, lost async
| page write

Signed-off-by: Christoph Fritz <chf.fritz@googlemail.com>
Cc: <stable@vger.kernel.org> # v4.14+
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: change quirks.c to be a header file

Rename quirks.c to quirks.h, and include it for
individual C files which need it.

Signed-off-by: Shawn Lin <shawn.lin@rock-chips.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

mmc: core: Move public functions from card.h to private headers

A significant amount of functions and other definitions are available
through the public mmc card.h header file. Let's slim down this public mmc
interface, as to prevent users from abusing it, by moving some of the
functions/definitions to private mmc header files.

This change concentrates on moving the functions into private mmc headers,
following changes may continue with additional clean-ups.

Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Shawn Lin <shawn.lin@rock-chips.com>