firmware: tegra: bpmp: Fix Tegra234-only builds

The tegra186_bpmp_ops symbol is used on Tegra234, so make sure it's
available.

Signed-off-by: Thierry Reding <treding@nvidia.com>

firmware/tegra: Enable Tegra186 BPMP support on Tegra194

The BPMP implementation on Tegra194 is mostly compatible with the
implementation on Tegra186, so make sure the latter is available when
support for Tegra194 is enabled.

Suggested-by: Timo Alho <talho@nvidia.com>
Reviewed-by: Timo Alho <talho@nvidia.com>
Tested-by: Timo Alho <talho@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>

firmware: tegra: Conditionally support SoC generations

Only include support for Tegra210 and Tegra186 in the BPMP driver if
support for those SoCs was selected. This fixes a build failure seen
on 32-bit ARM allmodconfig builds, but could also happen on 64-bit
ARM builds if either Tegra210 or Tegra186 were not selected.

Reported-by: Guenter Roeck <linux@roeck-us.net>
Reviewed-by: Timo Alho <talho@nvidia.com>
Tested-by: Timo Alho <talho@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>

firmware: tegra: add bpmp driver for Tegra210

This patch adds driver for Tegra210 BPMP firmware.

The BPMP is a specific processor in Tegra210 chip, which runs firmware
for assisting in entering deep low power states (suspend to ram), and
offloading DRAM memory clock scaling on some platforms.

Based on work by Sivaram Nair <sivaramn@nvidia.com>

Signed-off-by: Timo Alho <talho@nvidia.com>
Acked-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>

firmware: tegra: Refactor BPMP driver

Split BPMP driver into common and chip specific parts to facilitate
adding support for previous and future Tegra chips that are using BPMP
as co-processor.

Signed-off-by: Timo Alho <talho@nvidia.com>
Acked-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>