crypto: caam - use len instead of nents for bulding HW S/G table

Currently, conversion of SW S/G table into HW S/G layout relies on
nents returned by sg_nents_for_len(sg, len).
However this leaves the possibility of HW S/G referencing more data
then needed: since buffer length in HW S/G entries is filled using
sg_dma_len(sg), the last entry in HW S/G table might have a length
that is bigger than needed for the crypto request.

This way of S/G table conversion is fine, unless after converting a table
more entries have to be appended to the HW S/G table.
In this case, crypto engine would access data from the S/G entry having
the incorrect length, instead of advancing in the S/G table.
This situation doesn't exist, but the upcoming implementation of
IV update for skcipher algorithms needs to add a S/G entry after
req->dst S/G (corresponding to output IV).

Signed-off-by: Horia Geantă <horia.geanta@nxp.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>

crypto: caam - add SPDX license identifier to all files

Previously, a tree-wide change added SPDX license identifiers to
files lacking licensing information:
b24413180f56 ("License cleanup: add SPDX GPL-2.0 license identifier to files with no license")

To be consistent update the rest of the files:
-files with license specified by means of MODULE_LICENSE()
-files with complete license text
-Kconfig

Signed-off-by: Horia Geantă <horia.geanta@nxp.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>

staging: fsl-mc: Move DPIO from staging to drivers/soc/fsl

Move the NXP DPIO (Datapath I/O Driver) out of the
drivers/staging directory and into the drivers/soc/fsl directory.

The DPIO driver enables access to Queue and Buffer Manager (QBMAN)
hardware on NXP DPAA2 devices. This is a prerequisite to moving the
DPAA2 Ethernet driver out of staging.

Signed-off-by: Roy Pledge <roy.pledge@nxp.com>
Reviewed-by: Horia Geantă <horia.geanta@nxp.com>
Reviewed-by: Ioana Radulescu <ruxandra.radulescu@nxp.com>
Signed-off-by: Li Yang <leoyang.li@nxp.com>

crypto: caam/jr - add support for DPAA2 parts

Add support for using the caam/jr backend on DPAA2-based SoCs.
These have some particularities we have to account for:
-HW S/G format is different
-Management Complex (MC) firmware initializes / manages (partially)
the CAAM block: MCFGR, QI enablement in QICTL, RNG

Signed-off-by: Horia Geantă <horia.geanta@nxp.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>