sh: boards: convert to SPDX identifiers

Update license to use SPDX-License-Identifier instead of verbose license
text.

Link: http://lkml.kernel.org/r/87in08ct0n.wl-kuninori.morimoto.gx@renesas.com
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Reviewed-by: Simon Horman <horms+renesas@verge.net.au>
Cc: Rich Felker <dalias@libc.org>
Cc: Yoshinori Sato <ysato@users.sourceforge.jp>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

sh: mach-rsk: Add polled GPIO buttons support for RSK+7203.

Now that there's an upstream polled gpio-keys driver, add the outstanding
platform data for it.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

sh: Mass ctrl_in/outX to __raw_read/writeX conversion.

The old ctrl in/out routines are non-portable and unsuitable for
cross-platform use. While drivers/sh has already been sanitized, there
is still quite a lot of code that is not. This converts the arch/sh/ bits
over, which permits us to flag the routines as deprecated whilst still
building with -Werror for the architecture code, and to ensure that
future users are not added.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

sh: rsk7203 CONFIG_MTD=n fix

Fix the rsk7203 board code to build with CONFIG_MTD=n.

Signed-off-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

sh: smsc911x support for the rsk7203 board

This patch adds support for the LAN9118 ethernet on rsk7203.

The LAN9118 controller is hooked up using a 16-bit data bus,
but the rsk7203 board does not swap the byte lanes as needed
between the sh7203 processor and the the ethernet controller.

In the processor the CS memory window is configured in 16-bit
mode but the smsc911x driver is told to do 32-bit accesses to
improve performance. The SMSC911X_SWAP_FIFO flag is used
to tell the driver to do software byte swapping of fifo data.

Signed-off-by: Magnus Damm <damm@igel.co.jp>
Acked-by: Steve Glendinning <steve.glendinning@smsc.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

sh: convert rsk7203 to use smsc911x.

Signed-off-by: Steve Glendinning <steve.glendinning@smsc.com>
Signed-off-by: Nobuhiro Iwamatsu <iwamatsu.nobuhiro@renesas.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

sh: Consolidate rsk7203/7201 in to a new mach-rsk.

RSK+ platforms have quite a few characteristics in common, so roll them
together in to a shiny new RSK mach-type.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>