#
4d846d26 |
|
10-May-2023 |
Warner Losh <imp@FreeBSD.org> |
spdx: The BSD-2-Clause-FreeBSD identifier is obsolete, drop -FreeBSD The SPDX folks have obsoleted the BSD-2-Clause-FreeBSD identifier. Catch up to that fact and revert to their recommended match of BSD-2-Clause. Discussed with: pfg MFC After: 3 days Sponsored by: Netflix
|
#
2e6a8c1a |
|
30-May-2022 |
Justin Hibbits <jhibbits@FreeBSD.org> |
Mechanically convert etherswitch drivers to IfAPI Reviewed by: kd Sponsored by: Juniper Networks, Inc. Differential Revision: https://reviews.freebsd.org/D37813
|
#
d88aecce |
|
25-Oct-2021 |
Kornel Duleba <mindal@semihalf.com> |
felix: Add a sysctl to control timer routine frequency Driver polls status of all PHYs connected to the switch in a fixed interval. Add a sysctl that allows to control frequency of that. The value is expressed in ticks and defaults to "hz", or 1 second. Obtained from: Semihalf Sponsored by: Alstom Group
|
#
29cf6a79 |
|
26-Oct-2021 |
Kornel Duleba <mindal@semihalf.com> |
felix: Use internal MDIO regs for PHY communication Previously we would use an external MDIO device found on the PCI bus. Switch to using MDIO mapped in a separate BAR of the switch device. It is much easier this way since we don't have to depend on another driver anymore. Obtained from: Semihalf Sponsored by: Alstom Group
|
#
451bcf1b |
|
09-Jun-2021 |
Marcin Wojtas <mw@FreeBSD.org> |
Introduce driver for Freescale Felix switch It is found on boards equipped with LS1028A SoC. 802.1q VLAN grouping is supported. An external MDIO device is used for communicating with PHYs. The driver is built as a module by default, it is not included in GENERIC kernel config. Submitted by: Lukasz Hajec <lha@semihalf.com> Kornel Duleba <mindal@semihalf.com> Obtained from: Semihalf Sponsored by: Alstom Group Differential Revision: https://reviews.freebsd.org/D30923
|