Copy stable/9 to releng/9.3 as part of the 9.3-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

MFC r225941:
Fix an unaligned access issue; tidy up OFDM/DS rate decoding from the PLCP.

This fixes a panic on PPC.

Submitted by: novel
Obtained from: OpenBSD, sys/dev/ic/bwi.c r1.89

MFC r226181:
Update from OpenBSD: Include 0x4402 in the bbp id mapping table used on older devices.

http://bcm-specs.sipsolutions.net/BackPlane agrees.

Obtained from: OpenBSD, sys/dev/ic/bwi.c r1.88

MFC r226182:
Fix an incorrect use of sizeof().

Obtained from: OpenBSD sys/dev/ic/bwi.c r1.87

MFC r228621:
Fix some net80211 enum nits:
- ic_vap_create() uses an ieee80211_opmode argument
- ieee80211_rate2media() takes an ieee80211_phymode argument
- ieee80211_plcp2rate() takes an ieee80211_phytype argument
- cast to enum ieee80211_protmode and ieee80211_roamingmode to silence
compiler warnings

Submitted by: arundel@

Copy head to stable/9 as part of 9.0-RELEASE release cycle.

Approved by: re (implicit)

Remove unnecessary comments. 11A read/write is the same: its just the
classic indirect register dance.

Submitted by: ddkprog at yahoo not com

Fix a typo from the original driver. We need to write ctrl2 into RF
register 0x52, not ctrl1. This appears to be a mistake in the bcm
reverse engineering page, and has been corrected there. Tracing
through the code, this is more in keeping with the "documented"
register. Sephe thinks it looks interesting and may be worth
fixing. :)

Submitted by: ddkprog at yahoo com
Reviewed by: Sepherosa Ziehau

Add a comment to motivate my last change.

Suggested by: sam, imp

Add a short delay after programming PHY registers to give some time for
the engine to catch up. This prevents a machine check exception from
illegal memory requests with a BCM4318.

Bring in Andrew Thompson's port of Sepherosa Ziehau's bwi driver for
Broadcom BCM43xx chipsets. This driver uses the v3 firmware that
needs to be fetched separately. A port will be committed to create
the bwi firmware module.

The driver matches the following chips: Broadcom BCM4301, BCM4307,
BCM4306, BCM4309, BCM4311, BCM4312, BCM4318, BCM4319

The driver works for 802.11b and 802.11g.

Limitations:
This doesn't support the 802.11a or 802.11n portion of radios.
Some BCM4306 and BCM4309 cards don't work with Channel 1, 2 or 3.
Documenation for this firmware is reverse engineered from
http://bcm.sipsolutions.net/
V4 of the firmware is needed for 11a or 11n support
http://bcm-v4.sipsolutions.net/
Firmware needs to be fetched from a third party, port to be committed

# I've tested this with a BCM4319 mini-pci and a BCM4318 CardBus card, and
# not connected it to the build until the firmware port is committed.

Obtained from: DragonFlyBSD, //depot/projects/vap
Reviewed by: sam@, thompsa@