Copy stable/11@r303970 to releng/11.0 as part of the 11.0-RELEASE
cycle.

Prune svn:mergeinfo from the new branch, and rename it to RC1.

Update __FreeBSD_version.

Use the quarterly branch for the default FreeBSD.conf pkg(8) repo and
the dvd1.iso packages population.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Copy head@r302406 to stable/11 as part of the 11.0-RELEASE cycle.
Prune svn:mergeinfo from the new branch, as nothing has been merged
here.

Additional commits post-branch will follow.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Replace the A20 kernel config with a generic ALLWINNER kernel config that
supports A20, A31, and A31S. Adds support for the BananaPi M2 (A31S) board.

Submitted by: Emmanuel Vadot <manu@bidouilliste.com>
Reviewed by: jmcneill
Differential Revision: https://reviews.freebsd.org/D5580

Enable PHY regulator when the optional "phy-supply" property is present.

Submitted by: Emmanuel Vadot <manu@bidouilliste.com>

Convert Allwinner port to extres clk/hwreset/regulator APIs.

Reviewed by: andrew, gonzo, Emmanuel Vadot <manu@bidouilliste.com>
Approved by: gonzo (mentor)
Differential Revision: https://reviews.freebsd.org/D5752

Add the start of support for the Allwinner A31 clocks. It only adds
support for the i2c, mmc, and gmac clocks. Further clocks can be added as
needed.

Submitted by: Emmanuel Vadot <manu@bidouilliste.com>
Reviewed by: jmcneill
Differential Revision: https://reviews.freebsd.org/D5339

Move the Allwinner kernels to use fdt_pinctrl. This will read the pin
configuration from the FDT data, then set the pins into the requested
state. As part of this the gpio controller now reports the correct number
of pins instead of returning the number of bank * 32.

To allow for a future consolidated kernel we add the SOC_ALLWINNER_A10 and
SOC_ALLWINNER_A20 kernel options. These need to be set as appropriate for
the SoC the kernel will boot on.

Submitted by: Emmanuel Vadot <manu@bidouilliste.com>
Differential Revision: https://reviews.freebsd.org/D5177

Add the A20 glue code for if_dwc.

This code initializes the GMAC clock and sets the pin mux to rgmii.

It also override the if_dwc defaults to set the alternate descriptor type
and MII clock used on A20.

Tested on cubieboard2 and banana pi.