MFC r351397:

MFV r346563:

Update wpa 2.8 --> 2.9

hostapd:
* SAE changes
- disable use of groups using Brainpool curves
- improved protection against side channel attacks
[https://w1.fi/security/2019-6/]
* EAP-pwd changes
- disable use of groups using Brainpool curves
- improved protection against side channel attacks
[https://w1.fi/security/2019-6/]
* fixed FT-EAP initial mobility domain association using PMKSA caching
* added configuration of airtime policy
* fixed FILS to and RSNE into (Re)Association Response frames
* fixed DPP bootstrapping URI parser of channel list
* added support for regulatory WMM limitation (for ETSI)
* added support for MACsec Key Agreement using IEEE 802.1X/PSK
* added experimental support for EAP-TEAP server (RFC 7170)
* added experimental support for EAP-TLS server with TLS v1.3
* added support for two server certificates/keys (RSA/ECC)
* added AKMSuiteSelector into "STA <addr>" control interface data to
determine with AKM was used for an association
* added eap_sim_id parameter to allow EAP-SIM/AKA server pseudonym and
fast reauthentication use to be disabled
* fixed an ECDH operation corner case with OpenSSL

wpa_supplicant:
* SAE changes
- disable use of groups using Brainpool curves
- improved protection against side channel attacks
[https://w1.fi/security/2019-6/]
* EAP-pwd changes
- disable use of groups using Brainpool curves
- allow the set of groups to be configured (eap_pwd_groups)
- improved protection against side channel attacks
[https://w1.fi/security/2019-6/]
* fixed FT-EAP initial mobility domain association using PMKSA caching
(disabled by default for backwards compatibility; can be enabled
with ft_eap_pmksa_caching=1)
* fixed a regression in OpenSSL 1.1+ engine loading
* added validation of RSNE in (Re)Association Response frames
* fixed DPP bootstrapping URI parser of channel list
* extended EAP-SIM/AKA fast re-authentication to allow use with FILS
* extended ca_cert_blob to support PEM format
* improved robustness of P2P Action frame scheduling
* added support for EAP-SIM/AKA using anonymous@realm identity
* fixed Hotspot 2.0 credential selection based on roaming consortium
to ignore credentials without a specific EAP method
* added experimental support for EAP-TEAP peer (RFC 7170)
* added experimental support for EAP-TLS peer with TLS v1.3
* fixed a regression in WMM parameter configuration for a TDLS peer
* fixed a regression in operation with drivers that offload 802.1X
4-way handshake
* fixed an ECDH operation corner case with OpenSSL

Security: https://w1.fi/security/2019-6/\
sae-eap-pwd-side-channel-attack-update.txt

Copy head@r302406 to stable/11 as part of the 11.0-RELEASE cycle.
Prune svn:mergeinfo from the new branch, as nothing has been merged
here.

Additional commits post-branch will follow.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Update hostapd/wpa_supplicant to version 2.5.

Tested by several people on current@/wireless@.

Relnotes: yes

Merge hostapd / wpa_supplicant 2.0.

Reviewed by: adrian (driver_bsd + usr.sbin/wpa)

Merge wpa_supplicant and hostapd 0.7.3.

Import wpa_supplicant / hostapd 0.7.3.

Changes:

2010-09-07 - v0.7.3
* fixed fallback from failed PMKSA caching into full EAP authentication
[Bug 355]
* fixed issue with early D-Bus signals during initialization
* fixed X.509 name handling in internal TLS
* fixed WPS ER to use corrent Enrollee MAC Address in Credential
* fixed scanning routines ot improve AP selection for WPS
* added WPS workaround for open networks
* fixed WPS Diffie-Hellman derivation to use correct public key length
* fixed wpa_supplicant AP mode operations to ignore Supplicant and
scan result events
* improved SME operations with nl80211
* fixed WPS ER event_id handling in some cases
* fixed some issues with bgscan simple to avoid unnecessary scans
* fixed issue with l2_packet_ndis overlapped writes corrupting stack
[Bug 328]
* updated WinPcap to the latest stable version 4.1.2 in Windows
installer

2010-04-18 - v0.7.2
* nl80211: fixed number of issues with roaming
* avoid unnecessary roaming if multiple APs with similar signal
strength are present in scan results
* add TLS client events and server probing to ease design of
automatic detection of EAP parameters
* add option for server certificate matching (SHA256 hash of the
certificate) instead of trusted CA certificate configuration
* bsd: Cleaned up driver wrapper and added various low-level
configuration options
* wpa_gui-qt4: do not show too frequent WPS AP available events as
tray messages
* TNC: fixed issues with fragmentation
* EAP-TNC: add Flags field into fragment acknowledgement (needed to
interoperate with other implementations; may potentially breaks
compatibility with older wpa_supplicant/hostapd versions)
* wpa_cli: added option for using a separate process to receive event
messages to reduce latency in showing these
(CFLAGS += -DCONFIG_WPA_CLI_FORK=y in .config to enable this)
* maximum BSS table size can now be configured (bss_max_count)
* BSSes to be included in the BSS table can be filtered based on
configured SSIDs to save memory (filter_ssids)
* fix number of issues with IEEE 802.11r/FT; this version is not
backwards compatible with old versions
* nl80211: add support for IEEE 802.11r/FT protocol (both over-the-air
and over-the-DS)
* add freq_list network configuration parameter to allow the AP
selection to filter out entries based on the operating channel
* add signal strength change events for bgscan; this allows more
dynamic changes to background scanning interval based on changes in
the signal strength with the current AP; this improves roaming within
ESS quite a bit, e.g., with bgscan="simple:30:-45:300" in the network
configuration block to request background scans less frequently when
signal strength remains good and to automatically trigger background
scans whenever signal strength drops noticeably
(this is currently only available with nl80211)
* add BSSID and reason code (if available) to disconnect event messages
* wpa_gui-qt4: more complete support for translating the GUI with
linguist and add German translation
* fix DH padding with internal crypto code (mainly, for WPS)
* do not trigger initial scan automatically anymore if there are no
enabled networks

2010-01-16 - v0.7.1
* cleaned up driver wrapper API (struct wpa_driver_ops); the new API
is not fully backwards compatible, so out-of-tree driver wrappers
will need modifications
* cleaned up various module interfaces
* merge hostapd and wpa_supplicant developers' documentation into a
single document
* nl80211: use explicit deauthentication to clear cfg80211 state to
avoid issues when roaming between APs
* dbus: major design changes in the new D-Bus API
(fi.w1.wpa_supplicant1)
* nl80211: added support for IBSS networks
* added internal debugging mechanism with backtrace support and memory
allocation/freeing validation, etc. tests (CONFIG_WPA_TRACE=y)
* added WPS ER unsubscription command to more cleanly unregister from
receiving UPnP events when ER is terminated
* cleaned up AP mode operations to avoid need for virtual driver_ops
wrapper
* added BSS table to maintain more complete scan result information
over multiple scans (that may include only partial results)
* wpa_gui-qt4: update Peers dialog information more dynamically while
the dialog is kept open
* fixed PKCS#12 use with OpenSSL 1.0.0
* driver_wext: Added cfg80211-specific optimization to avoid some
unnecessary scans and to speed up association

2009-11-21 - v0.7.0
* increased wpa_cli ping interval to 5 seconds and made this
configurable with a new command line options (-G<seconds>)
* fixed scan buffer processing with WEXT to handle up to 65535
byte result buffer (previously, limited to 32768 bytes)
* allow multiple driver wrappers to be specified on command line
(e.g., -Dnl80211,wext); the first one that is able to initialize the
interface will be used
* added support for multiple SSIDs per scan request to optimize
scan_ssid=1 operations in ap_scan=1 mode (i.e., search for hidden
SSIDs); this requires driver support and can currently be used only
with nl80211
* added support for WPS USBA out-of-band mechanism with USB Flash
Drives (UFD) (CONFIG_WPS_UFD=y)
* driver_ndis: add PAE group address to the multicast address list to
fix wired IEEE 802.1X authentication
* fixed IEEE 802.11r key derivation function to match with the standard
(note: this breaks interoperability with previous version) [Bug 303]
* added better support for drivers that allow separate authentication
and association commands (e.g., mac80211-based Linux drivers with
nl80211; SME in wpa_supplicant); this allows over-the-air FT protocol
to be used (IEEE 802.11r)
* fixed SHA-256 based key derivation function to match with the
standard when using CCMP (for IEEE 802.11r and IEEE 802.11w)
(note: this breaks interoperability with previous version) [Bug 307]
* use shared driver wrapper files with hostapd
* added AP mode functionality (CONFIG_AP=y) with mode=2 in the network
block; this can be used for open and WPA2-Personal networks
(optionally, with WPS); this links in parts of hostapd functionality
into wpa_supplicant
* wpa_gui-qt4: added new Peers dialog to show information about peers
(other devices, including APs and stations, etc. in the neighborhood)
* added support for WPS External Registrar functionality (configure APs
and enroll new devices); can be used with wpa_gui-qt4 Peers dialog
and wpa_cli commands wps_er_start, wps_er_stop, wps_er_pin,
wps_er_pbc, wps_er_learn
(this can also be used with a new 'none' driver wrapper if no
wireless device or IEEE 802.1X on wired is needed)
* driver_nl80211: multiple updates to provide support for new Linux
nl80211/mac80211 functionality
* updated management frame protection to use IEEE Std 802.11w-2009
* fixed number of small WPS issues and added workarounds to
interoperate with common deployed broken implementations
* added support for NFC out-of-band mechanism with WPS
* driver_ndis: fixed wired IEEE 802.1X authentication with PAE group
address frames
* added preliminary support for IEEE 802.11r RIC processing
* added support for specifying subset of enabled frequencies to scan
(scan_freq option in the network configuration block); this can speed
up scanning process considerably if it is known that only a small
subset of channels is actually used in the network (this is currently
supported only with -Dnl80211)
* added a workaround for race condition between receiving the
association event and the following EAPOL-Key
* added background scan and roaming infrastructure to allow
network-specific optimizations to be used to improve roaming within
an ESS (same SSID)
* added new DBus interface (fi.w1.wpa_supplicant1)