- Copy stable/10@296371 to releng/10.3 in preparation for 10.3-RC1
builds.
- Update newvers.sh to reflect RC1.
- Update __FreeBSD_version to reflect 10.3.
- Update default pkg(8) configuration to use the quarterly branch.

Approved by: re (implicit)

MFC r274641, r274644, r274822, r276049:

Allow i2c bus speed to be configured via hints, FDT data, and sysctl.

Implement bus speed setting for OMAP4, AM335x, and imx5/6.

Fix the i2c bus speed divisors for TI OMAP4 and AM335x to give the
advertised 100, 400, and 1000 KHz speeds.

PR: 195009

MFC r267021:

FreeBSD, historically, has always used 8-bit addresses for i2c devices
(7-bit device address << 1), always leaving the room for the read/write
bit.

This commit convert ti_i2c and revert r259127 on bcm2835_bsc to make them
compatible with 8-bit addresses. Previous to this commit an i2c device
would have different addresses depending on the controller it was attached
to (by example, when compared to any iicbb(4) based i2c controller), which
was a pretty annoying behavior.

Also, update the PMIC i2c address on beaglebone* DTS files to match the
new address scheme.

Now the userland utilities need to do the correct slave address shifting
(but it is going to work with any i2c controller on the system).

Discussed with: ian

MFC r267834:

Clarify the expected usage of I2C 7-bit slave addresses on ioctl(2)
interface.

While here add the cross reference to iic(4) on iicbus(4).

CR: D210
Suggested by: jmg

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Expand contractions.

mdoc(7) police: removed HISTORY info from the .Os call.

mdoc(7) police: normalize .Nd.

Prepare for mdoc(7)NG.

Fix typos.

PR: 22922
Submitted by: Jimmy Olgeni <olgeni@uli.it>

Remove single-space hard sentence breaks. These degrade the quality
of the typeset output, tend to make diffs harder to read and provide
bad examples for new-comers to mdoc.

First round of config related changes to the manpages.

device blah0 -> device blah for PCI devices and busses.

Discourage usage of controller in kernel config files. Reflect this
by changing ``controller'' to ``device'' as per GENERIC and LINT.

$Id$ -> $FreeBSD$

Various man page cleanup:

- Sort xrefs
- FreeBSD.ORG -> FreeBSD.org
- Be consistent with section names as outlined in mdoc(7).
- Other misc mdoc cleanup.

PR: doc/13144
Submitted by: Alexey M. Zelkin <phantom@cris.net>

Add $Id$, to make it simpler for members of the translation teams to
track.

The $Id$ line is normally at the bottom of the main comment block in the
man page, separated from the rest of the manpage by an empty comment,
like so;

.\" $Id$
.\"

If the immediately preceding comment is a @(#) format ID marker than the
the $Id$ will line up underneath it with no intervening blank lines.
Otherwise, an additional blank line is inserted.

Approved by: bde

I2C framework manpages. See iicbus(4) for more info.