- Copy stable/10@285827 to releng/10.2 in preparation for 10.2-RC1
builds.
- Update newvers.sh to reflect RC1.
- Update __FreeBSD_version to reflect 10.2.
- Update default pkg(8) configuration to use the quarterly branch.[1]

Discussed with: re, portmgr [1]
Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

MFC r258268, r258271, r258272, r258274, r258275, r258427, r258694, r258696,
r258697, r258757

Do not assume a value for #address-cells when parsing the OF translations
map. This allows the kernel to get farther with OpenBIOS on 64-bit CPUs.

Actually look up #address-cells instead of assuming it is correlated with
the Uninorth version number.

#interrupt-cells belongs to the iparent, not the device parent.

Add a sysctl to allow disabling resetting the OF syscons.

For PCI<->PCI bridges, #address-cells may be 3.

Make RTAS calls, which call setfault() to recover from machine checks,
preserve any existing fault buffer.

badaddr() is used only in the grackle PCI driver, so move its definition
there. Clean up a spurious setfault() declaration as well.

This [phyp_console] driver doesn't need the /options node, so don't check
for it.

Use the Open Firmware-based CPU frequency determination as a generic
fallback if we can't measure CPU frequency. This is also useful on a
variety of embedded systems using FDT.

MFC r258615

Take care to handle the full 16 byte buffer in the get/put routines. Also,
skip the VTERM header once when receiving data from the hypervisor call when
we have a HVTERMPROT connection.

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Fix bug where UART unit number was not set properly, which prevented
operation on systems with multiple serial ports. Also turn on
interrupts for the UART device, which were disabled due to a
now-fixed bug in QEMU.

Approved by: re (gjb)

Merge in support for PAPR-compliant (Power Architecture Platform
Requirements) systems from the projects/pseries branch. This in principle
includes all IBM POWER hardware released in the last 15 years with the
exception of POWER3-based systems when run in 64-bit mode. The main
development target, however, has been the PAPR logical partition support
that is the default target in KVM on POWER and QEMU -- mileage may vary
on actual hardware at present. Much of the heavy lifting here was done
by Andreas Tobler.

Approved by: re (kib)